Abstract:In view of the limitations of the current code based on the equivalent beam-column method with the “rod mode” instead of the “arch mode” for the calculation of concrete-filled steel tube arch bridges, this paper takes the real bearing mechanism of the arch as the starting point and analyzes the different bearing mechanisms of the arch and eccentric pressurized column. The concrete-filled steel tube arch model test was carried out to analyze the deformation state and damage mode, and the geometric non-linear bending moment of the measured arch was compared with the bending moment value calculated by the eccentricity increase coefficient of the “rod mode.” The results showed that the transfer of internal force is from the axial force to the arch axis, causing the vertical reaction force and horizontal thrust. However, the eccentric compression column only produced the vertical force at the bottom and combines with the lateral deformation indirectly generated by the eccentric distance. In addition, the deformation stage of the arch is basically the same as that of the eccentric compression column. The final failure mode of the arch is 4-hinge damage, and the final failure mode of the eccentric compression column is single-hinge damage. The preliminary geometric non-linear bending moment value obtained by the two modes accords well. Therefore, the main factors for the difference in the bearing mechanism between the two modes are different force structures, force transmission routes, and sources of deformation. Due to the difference in the bearing mechanism, the final failure mode is different, and the deformation ability of the arch is weakened by using the “rod mode” instead of the “arch mode.” The geometric non-linear bending moment of the control section calculated by the eccentricity increase coefficient is conservative, but the influence of the geometric non-linearity of other sections is not considered enough.

Ultimate Bearing Capacity Analysis of Concrete Filled Steel Tubular Arch Bridges

Numerical Analysis of Ultimate Strength of Concrete Filled Steel Tubular Arch Bridges

Approach for Analyzing the Ultimate Strength of Concrete Filled Steel Tubular Arch Bridges with Stiffening Girder

Finite-element Analysis for Nonlinear Stabilities of Concrete-filled Steel Tubular Arch Bridges

Case Study on Stability Performance of Asymmetric Steel Arch Bridge with Inclined Arch Ribs

Test Study on Bearing Capacity of a New Steel-concrete Composite Arch

Parametric Study of In-Plane Ultimate Bearing Capacity of CFST Truss Rib Arch Bridge

SIMULATION ANALYSIS FOR MECHANIC BEHAVIOR OF CONCRETE-FILLED STEEL TUBULAR ARCH BRIDGE DURING THE COURSE OF CORE CONCRETE PUMPING

STUDY FOR IN-PLANE ULTIMATE STRENGTH OF STEEL CIRCULAR ARCHES WITH HORIZONTAL SPRING SUPPORTS

STUDY OF BEARING CAPACITY AND COMPLETE STRESS-STAIN CURVES FOR CONCRETE FILLED SQUARE STEEL TUBE COLUMNS

Analysis on the Ultimate Bearing Capacity of Small Eccentric Compression Component of Steel Tube with Infilled and Outer Concrete

Influence of Effective Prestress on Ultimate Bearing Capacity for Large-Span Prestressed Concrete Bridge

Optimum Design of Large Span Concrete Filled Steel Tubular Arch Bridge Based on Static, Stability and Modal Analysis

Behaviour Analysis of Prestressed Concrete Deck-Tied Arch Bridge

THE MECHANICAL PERFORMANCE OF SINGLE DIAGONAL LACING DOUBLE-WEB STAY MEMBERS OF OPEN CONCRETE FILLED STEEL TUBES WITH FOUR MAIN ELEMENTS

Field Test and Analysis for the Static and Dynamic Behaviour of Multi-Box Steel Concrete Composite Girder Bridge

Mechanical Behavior of Box Girder Bridge with Partial Corrugated Steel Webs

Analysis of stability of long-span concrete filled steel tube arched bridge in construction

Ultimate behavior of long-span steel arch bridges

A Study on the Ultimate Span of a Concrete-Filled Steel Tube Arch Bridge

Calculation model of concrete-filled steel tube arch bridges based on the “arch effect”