Photocatalytic Disinfection by Tio2 Immobilized on Glass Springs

CT Zeng,AP Chen,AH Chen,W Liu,ZM Dai
DOI: https://doi.org/10.3321/j.issn:0253-9837.2003.07.010
IF: 16.5
2003-01-01
Chinese Journal of Catalysis
Abstract:Two major problems encountered in the photocatalytic disinfection using TiO2 ultrafine particles are the counting of the bacteria number and the recovery of the photocatalyst particles from the purified water. A novel TiO2 photocatalyst immobilized on a glass spring support was developed for solving the problems. The catalyst was used in the photocatalytic disinfection of E. coli in water under the irradiation of blue-black UV light. The disinfection efficiency with UV light in the presence of TiO2 is much higher than that with UV light only. There is an induction period of about 15 min at the beginning of the photocatalytic disinfection process. The SEM and TEM photographs of the bacteria taken at different photocatalytic reaction time show that the photocatalytic reaction takes place on the cell walls and cell membranes of bacteria I breaking and then killing the cells. The effects of catalyst preparation conditions on the photocatalytic disinfection were investigated. The TiO2 slurry concentration, dip-coating cycle, and heat treatment have influence on the disinfection efficiency. High TiO2 slurry concentration results in more non-uniform distribution of TiO2 on the support and high calcination temperature makes the ultrafine TiO2 particles agglomerate and sinter. The disinfection efficiency is improved with increasing dip-coating cycle. The optimum conditions for the preparation of the immobilized photocatalyst are 2% TiO2 slurry concentration, 4 dip-coating cycles, and calcination at 400 degreesC for 2 h.
What problem does this paper attempt to address?