Surfactant Flooding in Tazhong 402CⅢ High-Temperature and High-Salinity Reservoir

Ji ZHAO,Ji-Chao FANG,Dai-Yu ZHOU,Jian-Hui ZHAO,Shi-Ti CUI,Cai-Li DAI,Hong ZHAO
DOI: https://doi.org/10.19346/j.cnki.1000-4092.2014.03.020
2014-01-01
Abstract:On account of the characteristics of high-temperature,high-salinity and high hardness of homogeneous section of Tazhong 402 CIII reservoir,betaine surfactant BS-12 and its applicable concentration were optimized. The performance of emulsification,adsorption and oil displacement was also evaluated. The results showed that under the reservoir condition(110℃,11.52×104mg/L salinity,7654 mg/L Ca2+and Mg2+),BS-12 solution had a good compatibility with formation water. The oil-water interfacial tension(IFT)was as low as 1.5×10-2—5.2×10-2mN/m with BS-12 concentration ranging from 0.03% to 0.05%. The IFT maintained by 2 orders of magnitude after aging for 30 days at 110℃,which indicated good thermostability. The emulsion formed by 0.03% and 0.05% BS-12 solution and crude oil was stable after 12 h,and the water separation rate of surfactant systems was69% and 50%,respectively. The droplets of emulsion showed a sparse distribution and its diameter ranged from 0.3 to 1.0 μm. The adsorption capacity on the surface of oil sands was tested with 20∶1 mass ratio of liquid to solid. The static adsorption was 6.592 mg/g. The dynamic adsorption was 4.938 mg/g and its retention was 1.411 mg/g. Finally,core displacement experiment results showed that the oil recovery increment was 4.14% after injecting 0.3 PV 0.2% BS-12 surfactant.
What problem does this paper attempt to address?