Effect of implant position and number on stress distribution when rigid connection is designed between implant bridge and attachment for edentulous maxilla
Xiao-mei LI,Lu-lu GONG,Shao-hai WANG,Da-lin WANG,Qiang ZHU
DOI: https://doi.org/10.3969/j.issn.1009-3761.2011.02.015
2011-01-01
Abstract:Objective: To study effect of implant position and number on stress distribution among implant and denture with 3-D finite element analysis.Method: A special denture is made for an edentulous maxilla cast to collect 3-dimensional finite element data.Three dimensional finite element mode is constructed by CT scanning technology through modifying position and numbers of implants when rigid attachment is used.Model 1:4 implants,in bi-side canine and central incisor;Model 2 :4 implants,in bi-side canine and lateral incisor,Model 3:6 implants,in bi-side canine,central incisor and lateral incisor;The part of attachment which connected to implant bridge is call positive part,the other part which connected to removable denture is called negative part.Results: Among the three models,canine implant exhibit the highest stress which all lies in neck of the implant,which is: model 3<model 2<model 1 in turn,Maximum stress in canine of model 1 is about 1.85 times higher than that of model 3,Maximum stress in canine of model 1 is about 10 times higher than central incisor,model 2 is about 5 times higher than lateral incisor.Maximum stress in lateral incisor and central incisor of model 3 is near to that of lateral incisor in model 2 and central incisor of model 1 respectively.Maximum stress in positive part and negative part of attachment of model 1 is higher than that of model 2 and model 3,especially negative part,is about 4 times higher than of model 2 and model 3.Maximum stress in palate plate is centralized mainly in connection between attachment and palate plate,then the connection part between palate plate and resin base,and then in corner between horizontal part and vertical part.Conclusion: 6 implants in front region seems to be more reasonable.Enough strength should be paid more attention in connection between attachment and alloy frame,palate plate and resin base.