Preparation of α-FeOOH loaded chitosan composite and its efficient removal for Cr(VI)
Shengli Zhang,Mingxi Wang,Zhili Du,Yiyue Yang,Diyang Yu,Hongwei Yang,Maohong Li
DOI: https://doi.org/10.1016/j.jwpe.2024.105842
IF: 7
2024-07-26
Journal of Water Process Engineering
Abstract:FeOOH has a large specific surface area and numerous active binding sites for Cr(VI), but it usually exists in the form of powder, being agglomerate easily and difficult for recycling after use. In this study, the in-situ generation of α-FeOOH and the shaping of CS spheres simultaneously happened in the mixed solution of 2 mol/L NaOH and 1 wt% of PEI, and then the rusultant spheres were crosslinked in 3 % glutaraldehyde solution to obtain the α-FeOOH loaded chitosan composite (α-FeOOH-PEI-CS). It had a connected three-dimensional reticular structuree, being easily separated. Under the optimal adsorption conditions (pH = 2.5, reaction temperature of 35 °C and adsorbent dosage of 0.5 g/L), the maximum adsorption capacity of the α-FeOOH-PEI-CS for Cr(VI) reached 250.63 mg/g. The adsorption process was consistent with the pseudo-second-order kinetic model, and intraparticle diffusion was the main rate-limiting step. In addition, the α-FeOOH-PEI-CS had good anti-interference and reusability. Coexisting anions and cations except SO 4 2− had no significant effect on the adsorption of Cr(VI), and the removal rate still maintained above 97 % after 5 cycles. The adsorption mechanism included electrostatic attraction, reduction of Cr(VI) to Cr(III) and chelation of Cr(III) by amino and carboxyl groups.
engineering, chemical,water resources, environmental