Abstract:Objective To determine the biomechanical variation in full-length femoral stress pat-tern and periprosthetic femoral stress distribution after implantation either with Charnley Elite cemented prostlesis or Summit proximal porous cementless femoral prosthesis. Methods Three-dimensional finite element models of intact femur, Charnley Elite and Summit femoral prostheses were developed. The stress distributions on the femur and the implants were measured. Applied with hip joint loading and related muscles strength, the stress changes of an intact femur and those implanted with either Charnley Elite or Summit protheses, especially changes in proximal femur, were respectively quantitatively analysed. Results Com-pared with intact femur, there was no change of the full-length femur stress pattern in implantation of both implants, the areas of peak values were all presented at middle and lower regions of the femur, and femoral stress value levels were decreased with both implants. Both prostheses induced significant decrease of stress in the periprosthetic bone tissue, the most serious loss of stresses all appeared at femoral calcar, the stress-shielding rates of Elite and Summit prostheses were 90.8% and 95.3% respectively. The distributions of stress shielding of both prostheses were consistent each other, the Summit proximal porous cementless pros-thesis had more serious stress decrease than the Charnley Elite cemented prosthesis. Conclusion Implan-tation of both implants may cause significant stress shielding in the proximal femur. This may be related with periprosthetic bone loss and aseptic loosening of stems, and can be used to explain the mechanism of post-operative femoral fracture and thigh pain. Both implants designs need further improvement to reduce stress changes in proximal femur.

Stress Finite Element and Analysis of Stem after Total Hip Replacement

Stress Calculation and Analysis on the Stem of Artificial Hip Joint under Loads

Finite Element Analysis of Femoral Stress Changes after Total Hip Arthroplasty

Stress finite element and analysis of femoral defect after artificial hip arthroplasty replacement

[Three-Dimensional Finite Element Analysis of Bone Stress Distribution Around the Hip Joint Prosthesis with Stepped Stem].

Finite element analysis of the short-stem prothesis in femoral head replacement among the elderly femoral neck fractures

Theoretical analysis of changes in femoral stresses after total hip arthroplasty]

Stress Analysis and Shape Design of a Femoral Hip Prosthesis

Finite element analysis of changes in femoral stresses after elite total hip arthroplasty]

In vivo finite element modeling and mechanical analysis of artificial hip joint

Three-dimensional finite element analysis of hip joint replacement

[Analysis on Morphology and Stability of Femoral Hip Prosthesis Based on the Revision Operation].

The effect of stem structure on stress distribution of a custom-made hip prosthesis.

An Innovative Design and Structural Mechanics Analysis of Artificial Hip Joint

Three-dimensional Finite Element Analysis Modeling of the Post-Implanting Femur and Statics Analysis of Femur Prothesis Bone Interface

The Finite Element Analysis of Cemented Long and Short Stem Prosthetic Replacement in Aged Patients with Comminuted Intertrochanteric Fracture

The Finite Element Analysis Of The Shape Of The Femoral Head Prosthesis On The Influence Of The Hip Joint

Finite Element Analysis of Tibia after Revision of TKA Through Impaction Bone Grafting

The three-dimensional finite element analysis of the human femur

Mechanical Analysis and Reasoning on Fractured Stem Failure after Total Hip Arthroplasty

Key Parameters Evaluation for Hip Prosthesis with Finite Element Analysis