Abstract:The clearance flow of compressor variable stator vanes has a significant impact on compressor performance. Most clearance flow experimental research work has been carried out in compressor cascades with lower turning angle (lower load). The clearance flow in a higher load compressor cascade is relatively more complicated due to three-dimensional (3D) flow separation. In the present work, the effects of different heights and locations of clearances in a compressor cascade on aerodynamic performance and separation flow were investigated experimentally in a low-speed plane cascade wind tunnel. The objective of this investigation is to study the characteristics of different clearance configurations depending on the clearance height and the clearance axial position, and make an attempt to verify the possibility of a local clearance flow that improves the performance. The cascade outlet section aerodynamic parameters were measured by L five-hole probe. The ink-trace flow visualizations on the cascade surface and lower end wall were performed. The results show that with the increase in clearance size, the core area of high loss is moving to the end wall and the morphology of limiting streamlines on the suction surface changes gradually from separation lines to reattachment lines. The separation lines on end wall gradually moved to the middle of the cascade and the separation area increased gradually. The above reasons caused high loss zone gradually extended to the end wall. Thus, the loss at mid-span declined slightly while the loss on the end wall was increasing. Otherwise, cascade load reduced significantly when the clearance height became 3mm, and the change magnitude of limiting streamline morphology in the flow field which was influenced by clearance flow at the rear of the blade reached to a minimum. So the loss and load came to a minimum, respectively. The impact of the clearance in the rear of a blade on loss and flow is weaker than the other schemes, with a slightly larger loss and separation with respect to the original scheme without a clearance. It may be expected to improve the cascade performance further by an appropriate design of clearance near the trailing.

Experimental Study of the Effect of Blade Tip Clearance on Turbine Performance

Effect of Different Incidences on Turbine Cascades Flow in Blade Tip Clearance

Numerical Investigation on the Effect of Tip Clearance on a Turbine Stage Flow-field and Aerodynamic Performance

Experimental and Numerical Study of Wall Flow Pattern of Turbine Cascade with Tip Clearance

NUMERICAL SIMULATION STUDY ON THE EFFECT OF TIP CLEARANCE ON PERFORMANCE OF A TRANSONIC AXIAL FAN

Experimental Study on Axially Non-Uniform Clearances in a Linear Turbine Cascade with a Cavity Squealer Tip

Numerical Study of the Flow in Axial Cascade with Tip Clearance

Experimental Investigation of Aerodynamic Performance due to Blade Tip Clearance in a Gas Turbine Rotor Cascade

Effects of tip clearance flow on aerodynamic performance of transonic axial compressor rotor

Experiment Study of Aerodynamic Performance for the Suction-Side and Pressure-Side Winglet-Cavity Tips in a Turbine Blade Cascade

The effect of different clearance geometry configurations on aerodynamic performance in a high-load compressor cascade

Topology and Vortex Structures of Turbine Cascade with Different Tip Clearances

Experimental Investigation of the Bending Clearance on the Aerodynamic Performance in Turbine Blade Tip Region

Effect of Tip Clearance on Compressor Performance

Effects of Tip Injection in Different Locations on Clearance Leakage Flow of Turbine

Numerical investigation on the influence of nonuniform tip clearance on rotor tip-clearance flow field structure

Aerodynamic performance of tip leakage flow of two different blade tips in transonic turbine

Numerical and Experimental Investigations of Tip Clearance Effects in a High-Flow-coefficient Centrifugal Compressor

Influence of Tip Clearance Size on Flow Characteristics of a Vaneless Counter-Rotating Turbine

Experimental and Numerical Investigations for Dual−Cavity Tip Aerodynamic Performance in the Linear Turbine Cascade

Experimental and numerical investigations of tip clearance flow and loss in a variable geometry turbine cascade