Abstract:Objective . Noninvasive measurement of oxygen saturation (SpO 2 ) using pulse oximetry based on transmissive photoplethysmography (tPPG) is clinically accepted and widely employed. However, reflective photoplethysmography (rPPG) - present in smartwatches - has not become equally accepted, partially because the pathlengths of the red and infrared PPGs are patient-dependent. Thus, even the most popular "Ratio of Modulation" (R) method requires patient-dependent calibration to reduce the errors in the measurement of SpO2 using rPPGs. Approach . In this paper, a correction factor or "pathlength ratio" β is introduced in an existing calibration-free algorithm that compensates the patient-dependent pathlength variations, and improved accuracy is obtained in the measurement of SpO2 using rPPGs. The proposed β is derived through the analytical model of a rPPG signal. Using the new expression and data obtained from a human hypoxia study wherein arterial oxygen saturation values acquired through Blood Gas Analysis were employed as a reference, β is determined. Main results . The results of the analysis show that a specific combination of the β and the measurements on the pulsating part of the natural logarithm of the red and infrared PPG signals yields a reduced root-mean-square error (RMSE). It is shown that the average RMSE in measuring SpO2 values reduces to 1 %. Significance . The human hypoxia study data used for this work, obtained in a previous study, covers SpO 2 values in the range from 70 % to 100 %, and thus shows that the pathlength ratio β proposed here works well in the range of clinical interest. This work demonstrates that the calibration-free method applicable for transmission type PPGs can be extended to determine SpO 2 using reflective PPGs with the incorporation of the correction factor β. Our algorithm significantly reduces the number of parameters needed for the estimation, while keeping the RMSE below the clinically accepted 2 %.

Methods of Pulse-Blood Oxygen Sensor's Noise Removal

Model Design and System Implementation for the Study of Anti-motion Artifacts Detection in Pulse Wave Monitoring

A New Noise Removed Method Based on Noise Concept

An Improved Method Based on Wavelet Threshold to Eliminate the Noise of Blood Oxygen Detection Signal

[Study on a Non-Invasive Wide-Range Blood Oxygen Saturation Detecting Method and Its Instrument Design].

A vital sign signal noise suppression method for wearable piezoelectric devices

SpO2 Measurement Algorithm for PPG Signal with Motion Artifacts

[Research on dynamic blood oxygen saturation measurement based on motion noise reconstruction combined with convex combination least mean square adaptive filter]

Vital Sign Extraction in the Presence of Radar Mutual Interference.

Noise reduction in the surface plasmon resonance array sensor

Non-invasive method and experimental study for measurement of oxygen saturation rate in wide range

Design of Non-invasive Oximeter

New Real-time Method for Pulse Wave Process and Pulse Rate Estimation in Dynamic Measurement of Pulse Oxygen Saturation

A Study of Data Processing Methods for Non‐Contact Multispectral Method of Blood Oxygen Saturation

Adaptive low-power wrist SpO2 monitoring system design using a multi-filtering scheme

Design of Non-invasive Pulse Oximetry Surveillance System

Dynamic Blood Oxygen Saturation Monitoring Based on a New IPPG Detecting Device

A Background-Subtraction Strategy Leads to Ratiometric Sensing of Oxygen Without Recalibration

Accuracy enhancement in reflective pulse oximetry by considering wavelength-dependent pathlengths

Wrist02 -- Reliable Peripheral Oxygen Saturation Readings from Wrist-Worn Pulse Oximeters

Robust Modelling of Reflectance Pulse Oximetry for SpO$_2$ Estimation