Study on Integrated Process of Catalytic Cracking Cycle Oil-Aromatic Extraction

LI Dong-sheng,LI Xiao-ou,ZHAI Yu-chun,TANG Zhi-fang,HAO Qing-xin,CHEN Li-fei

DOI: https://doi.org/10.3969/j.issn.1002-3119.2002.06.002

2002-01-01

Abstract:Integrated process of catalytic cracking cycle oil-aromatic extraction is about that the catalytic cracking cycle oil is extracted by the extract oil from the extraction tower of lubricant furfural refining unit under the conditions of adding or not adding reverse extraction solvent, then the raffinate oil turn back to the catalytic cracking unit and the extract oil turn back to the solvent recovery unit of the lubricant furfural refining.The extraction laboratory scale test is mainly introduced,investigating the influence of the solvent-oil ratio,temperature and the dose of reverse extraction solvent on the extraction effect and getting the proper laboratory scale test operation conditions,which present foundation for the middle scale test.The experimental result shows that,the extract oil can be used as solvent when it is only used as the filled oak oil,a fitting operation condition that the cycle oil is well extracted is at a solvent-oil ratio of 1.5(weight),a top temperature of the extraction tower of about 70℃,the bottom temperature of under 50℃,not adding reverse extraction solvent.And the yield of the raffinate oil is about 75%,of which the saturated constituents are increased from 55% to 77% or so,the carbon residue is about 0.25,the total sulfur concentration is about 900 μg/g,and the total nitrogen concentration is about 550 μg/g,of which the aromatic and resin constituents are over 90%.Adding the reverse extraction solvent is helpful for improving the aromatic content of the extract oil in order to get general use.