Abstract:The pollution of surface water is becoming more and more serious with the economic development. The requirements for the drinking water quality was higher than before since the "Standards for Drinking Water Quality" (GB/T 5749-2006) was implemented. In order to remove the organic pollutants, ozonation was employed as a tool in the drinking water treatment process, and the ozone contactor was used to make ozone diffused into the water. The ozone distribution is a key factor to the reaction efficiency between ozone and the organic pollutant in ozone contactor. The influence of ozone distribution in the ozone contactor on mass transfer efficiency, O3 content and organic removal efficiency was investigated, while water samples were collected from the Miyun Reservoir. The gas-liquid mass transfer was enhanced, and the removal efficiency of organic pollutant was improved when the number of aeration point increased. However, the mass transfer efficiency of ozone showed no significant increase when four-point aeration was used. Moreover, O3 content in the effluent water was too high for the following process. The mass transfer efficiency of ozone in the water was 78.1%, and the removal efficiency of oganics was 47.5% when three-point aeration was used, with the proportion of 3:3:1. When humic acid of 3 mg/L was added in the water samples, the mass transfer efficiency of ozone was 76.8%, and the removal efficiency of oganics was 40.3% using the same method. The O3 content in the effluent water was 0.26 mg/L, which would not destroy the biofilm on the surface of the activated carbon in biological activated carbon progress. At the proportion of 3:3:1, the utilization ratio of ozone value was the highest (60.1%), and the generation amount of bromate was the lowest. Therefore, the best method of gas distribution in ozone contactor was three-point aeration, with the proportion of 3:3:1.

Pilot-Scale Study on the Impact of Ozone Dosage on O3/BAC Process for Advanced Treatment Reservoir Water

Comparison of O3 - BAC Combination and Conventional Processes on Removal of Pollutants for Treating Drinking Water

STUDY ON THE OZONE PRE-OXIDATION DOSING QUANTITY OPTIMIZATION IN O3-BAC PROCESS

Ozone Dosage of Advanced Treatment Processes for Raw Water from Huangpu River

Operation Optimization of O3 -BAC Advanced Treatment Process for Drinking Water

Optimization of Parameters and Characteristics of Organics Removal with Preozonation-BAC Processes for Micropolluted Raw Water

Study of ozone dosage via disinfection by-product formation potential controlling in drinking water treatment

Pilot plant study on function of ozonation in biological activated carbon process

Pilot-scale Study on O_3/BAC Process for Advanced Treatment of Miyun Reservoir Water

Study on the Steady Operation of Ozone/Biological Activated Carbon Process

PILOT STUDIES ON OZONE-BIOLOGICAL ACTIVATED CARBON PROCESS FOR TREATING MICRO-POLLUTED RAW WATER IN HUANGPUJIANG RIVER

PILOT RAW WATER ADVANCED TREATMENT BY O_3-BAC PROCESS IN SUB-TROPICAL AREA

Optimization of Ozone Distribution Method in the Ozone Contactor

Effects of Ozonation on Disinfection By-Product Formation Potentials and Biostability in a Pilot-Scale Drinking Water Treatment Plant with Micro-Polluted Water.

Study on Functions of Ozone in Drinking Water Treatment by O3-BAC Process

Characteristics of Organic Matter Removal of Micro-Polluted Raw Water from Yangtze River with Ozone-Biological Activated Carbon (O3 BAC) Treatment Processes

Comparison of Micropollutants' Removal Performance Between Pre-Ozonation and Post-Ozonation Using a Pilot Study.

The formation and control of ozonation by-products during drinking water advanced treatment in a pilot-scale study

Control of the Ozonation By-Products by O<sub>3</sub>/BAC in Shanxi Yellow River Water Treatment

A study on removing ammonia nitrogen from micro-polluted source water using O3-BAC

Determination for Optimal Ozone Dose in O3-BAC