Abstract:The central diaphragm is often used to reduce the span to maintain the stability and safety of structure in the construction of large-span loess tunnel due to the structure complexities. In this paper, relying on the field monitoring and measurement for Wangcun tunnel in Huangling-Yan’an expressway expansion project, the crown settlement and horizontal convergence of primary support steel rib and central diaphragm steel rib during the construction are analyzed by the upper bench CD method. According to the internal force transfer, deformation coordination, and arch foot displacement between the two structures, the support system is regarded as the arch-beam fixed structure with three times of statically indeterminate and movable abutment under the loads, and the mechanical calculation model of sidewall steel rib and the central diaphragm structure bearing loads and deformation together is established. Finally, through the mechanical model mentioned above, the deformation characteristics of central diaphragm structure and the horizontal convergence in the upper bench of tunnel are calculated and analyzed. The research shows the following: (1) the accumulated settlement of sidewall steel rib in Part I is greater than that of the sidewall steel rib in Part II, and the accumulated settlement of each part at the support structure during the tunnel excavation is less than the reserved deformation of 150 mm specified in the tunnel excavation; (2) the settlement located at the waist and maximum excavation line position of central diaphragm is mainly affected by the excavation of Parts I and II in upper bench; (3) during the whole excavation process, the excavation of Part I and Part II has the greatest influence on the convergence at arch waist and the maximum excavation line position in Part I, and the convergence at the above two positions all experienced four stages of “convergence-expansion-convergence-gradual stability”; and (4) the errors between the horizontal convergence and the deformation of central diaphragm obtained by the mechanical model and the field monitoring data are between 12.7% and 27.5%. The calculated results are in good agreement with the actual situation. The research can provide a theoretical basis for the study of deformation and mechanical properties for support structure in the construction of large-span loess tunnel by the upper bench CD method.

3D Finite Element Method Analysis of Displacement of Expressway Tunnel During Entire Dynamic Construction Process

Theoretical Analysis of Longitudinal Vertical Displacement of Subway Tunnels Caused by the Construction of Steel Casings for Bridge Piles

Analysis on the longitudinal deformation of tunnels due to pit excavation considering the tunnel shearing effect

Numerical Dynamic Simulation of the Construction Mechanics and Comparison and Choice of the Construction Method in the Bi-arch Tunnel of Express Highway

Analysis of the influence of open-cut undercrossing of a national highway in Hangzhou on the existing municipal viaduct piers

ANALYSIS OF STRESS AND DISPLACEMENT AROUND A DEEP CIRCULAR TUNNEL IN VISCOELASTIC SOIL

Measurement on Soil Deformation and Numerical Simulation During Tunneling Process

Study on the Influence and Control Methods of Shield Tunneling Through the Sensitive Buildings

COMPREHENSIVE STUDY ON PREDICTION OF ROCKBURST IN DEEP AND OVER-LENGTH HIGHWAY TUNNEL

Study on the Stress and Deformation of Surrounding Rock and Support Structure of Super Large Section Tunnels Based on Different Excavation Methods

Analytical Method for Predicting Tunnel Heave Due to Overlying Excavation Considering Spatial Effect

Effect of foundation pit excavation and structural construction of new engineering on existing underlying tunnel

Study of Deformation Behaviors and Mechanical Properties of Central Diaphragm in a Large-Span Loess Tunnel by the Upper Bench CD Method

Numerical Simulation of Mechanical Response of Bridge Foundation and Existing Tunnel Caused by Pipe Jacking Construction

ANALYSIS OF TIME-SPACE EFFECTS OF CONSTRUCTION BEHAVIOR OF DEEP SOFT ROCK TUNNEL

Dynamic Construction Mechanics Analysis of Xiamen Sub-sea Tunnel in Terrestrial Shallow Section

Construction practice of water conveyance tunnel among complex geotechnical conditions: a case study

3D Numerical Simulation for Construction of Shallow Double Arched Tunnel under Bias Pressure

Stability Analysis on the Surrounding Rock of Large Span Highway Tunnel in Soft Rock

Automatic Modeling and Optimization Design Platform for Highway Tunnels with Application to Stress and Displacement Prediction of Surrounding Rocks during Tunnel Excavation

A New Numerical Finite Strain Procedure for a Circular Tunnel Excavated in Strain-Softening Rock Masses and Its Engineering Application