Abstract:Abstract Purpose One of the key challenges in the research of phononic crystals is achieving small-size control of large wavelengths, which means obtaining low-frequency band gaps with relatively small lattice dimensions. Previous studies have mostly been unsatisfactory in this regard. To obtain lower starting frequencies and more satisfactory band gap widths, this work presents a novel design for a phononic crystal structure. Design Approach The proposed phononic crystal consists of a silicon rubber connecting plate, an epoxy resin substrate, and tungsten metal cone scatterers. Through finite element method (FEM) calculations and analysis, we have successfully achieved an ultrawide band gap. To delve further into the origin of the ultra-wideband gap in a newly conceived phononic crystal, the vibrational modes of this crystal were carefully studied. Findings This work has successfully achieved an ultrawide band gap with a width ranging from 122.47 to 4360.2 in the case of a lattice constant of a = 8.5 mm. It was found that the low-frequency ultra-wideband gap cannot be obtained without the presence of silicone rubber. Furthermore, an equivalent spring model was developed, and the accuracy of this model was successfully validated through meticulous calculations. At last, It is found that d1, d4, h1, and h3 have the most pronounced effect on the ultrawide bandgap, and the intrinsic reason is the fact that they determine the geometric structure of the silicone rubber connection plate. Research Limitations/implications Due to the chosen research method of finite element analysis, the study results may vary depending on the different mesh discretizations, but this type of error is small and can be ignored. Practical Implications This work provides a new design solution for phononic crystal miniaturization. Originality/value Compared with previous reports, the new phonon crystals designed in this paper have smaller size, lower starting frequency, and wider band gap.

Research on Vibration Band Gaps of Phononic Crystals Consisting of Scattering Cells

Exact Solution to Band Structures of One-Dimensional Viscoelastic Functionally Graded Phononic Crystals

Multi-band Design for One-Dimensional Phononic Crystals

Study of Band Gaps of Two-Dimensional Phononic Crystals with Criss-Crossed Elliptical Holes

Bandgap Structures Of Sh-Wave In A One-Dimensional Phononic Crystal With Viscoelastic Interfaces

Thermal Tuning of the Interfacial Adhesive Layer on the Band Gaps in a One-Dimensional Phononic Crystal

Experimental and Theoretical Investigation of Lowering the Band Gaps of Phononic Crystal Beams Through Fluid-Solid Coupling

Large One-Dimensional Band Gaps in Three-Component Phononic Crystals Plates

Thermal tuning of band structures in a one-dimensional phononic crystal

Band gaps in phononic crystals: Generation mechanisms and interaction effects

Study on the band gap variation caused by constructed materials in a sandwich phononic crystal

Effects of void geometry on two-dimensional monolithic porous phononic crystals

Broadening Band Gaps of Bragg Scattering Phononic Crystal With Graded Supercell Configuration

Analysis of Flexural and Torsional Vibration Band Gaps in Phononic Crystal Beam

Properties of Photonic Bandgap in One-Dimensional Mutlicomponent Photonic Crystal

Low-Frequency Ultrawide Band Gap Study of Symmetric Conical Scatterer Phononic Crystal

Band structures of two dimensional solid/air hierarchical phononic crystals

Band gaps of elastic waves in 1-D dielectric phononic crystal with the flexoelectric and strain gradient effects consideration

The Existence of Simultaneous Bragg and Locally Resonant Band Gaps in Composite Phononic Crystal

Thickness-Modulated One-Dimensional Periodic Phononic Crystal

Band Structures of Phononic-Crystal Plates in the Form of A Sandwich-Layered Structure