Abstract:The performance of photovoltaic (PV) systems is known to degrade with temperature increase. To mitigate this issue, Phase Change Materials (PCMs) are utilized to regulate the temperature of PV modules. Many researchers have addressed the utilization of PCMs for thermal regulation of building integrated PVs (BIPV-PCM systems). Potential of integrating PV-PCM systems into membrane structures is relatively unexplored, it represents the novelty of this study. This paper explores the potential advantages and challenges of the thermal performance of OPV-ETFE foils with and without PCM integration under varying conditions. A detailed parametric analysis has been carried out to assess the impacts of ambient conditions and PCM properties under standard testing conditions. The results of this investigation offer critical insights into the thermal dynamics of OPV-PCM-ETFE modules and their application in building environments. A range of PCMs is analyzed and notably, Rubitherm-28 outperformed them, offering a 20-minute delay in temperature rise, showcasing its efficacy in thermal regulation for the OPV-PCM-ETFE module. Additionally, results indicate that an increase of 100 W/m 2 in solar radiation or 5 °C in ambient temperature consequently raised the OPV surface temperature by 5 °C. PCM thickness emerged as a critical factor for this integration. Each millimeter of PCM thickness adds approximately a 2-minute delay to the melt duration but owing to the low thermal conductivity property of both ETFE and PCMs, larger thickness can cause overheating issue. Therefore, it is recommended to use PCMs with higher latent heat capacity and melting points at least 10 °C above ambient temperature. The multi-parametric analysis further validated the flexibility of this approach across various conditions. An adaptive control strategy, informed by these findings, demonstrated potential for enhancing thermal management in OPV-PCM-ETFE modules using different control criteria. The adaptive control strategies help to optimize the thermal performance of the system and mitigate any potential overheating issues.

Energy Performance of ETFE Cushion Roof Integrated Photovoltaic/thermal System on Hot and Cold Days

Experimental Studies on Summer Performance and Feasibility of a BIPV/T Ethylene Tetrafluoroethylene (ETFE) Cushion Structure System

Estimation of Thermal Performance of Pv-Etfe Cushion Roof

Thermal Performances of ETFE Cushion Roof Integrated Amorphous Silicon Photovoltaic

Two-layer ETFE Cushions Integrated Flexible Photovoltaics: Prototype Development and Thermal Performance Assessment

Novel BIPV/T ETFE cushion

Photothermal-structural-fluid Behaviors of PV-ETFE Cushion Roof in Summer: Numerical Analysis Using Three-Dimensional Multiphysics Model

Photothermal Performance of an Amorphous Silicon Photovoltaic Panel Integrated in a Membrane Structure

Structural Behavior of the PV–ETFE Cushion Roof

Field measurement of temperature of PV-ETFE cushion structures

A multifunctional curved CIGS photovoltaic/thermal roof system: A numerical and experimental investigation

Investigation of the Performance of Photovoltaic/Thermal System by A Coupled Trnsys and Cfd Simulation

On-site Measured Performance of a Mechanically Ventilated Double ETFE Cushion Structure in an Aquatics Center

Experimental & numerical investigation and optimization on a novel flat-plate PV/T system using CdfTe thin-film solar modules of sandwich structure

On-site Measurement and Ventilation Improvement of an Aquatics Center Using Double ETFE Cushion Structure

Ventilation and Heat Dissipation Analysis of Photovoltaic Roof

Daylight and thermal performance of a switchable ethylene tetra-fluoro-ethylene cushion with dynamic control in different climates

Thermal performance of ethylene tetrafluoroethylene foils integrated organic photovoltaics and phase change materials for building envelopes: A numerical study

Design and Experimental Study of a Novel Flexible PV/T Structure

Experiments on Performances of ETFE Cushion and Properties of ETFE Film in High Temperature

Performance analysis on the concentrated photovoltaic /thermal air collector with phase change material and vacuum double-glazing for temperature regulation