Abstract:The lithium-ion battery has the advantages of high energy density, long service life, and good safety performance, and is used as an ideal energy storage device. Cobalt-free lithium-rich manganese cathode materials have attracted much attention due to their high specific capacity and low cost. However, its poor cycling performance is not conducive to practical application. So far, researchers have mainly addressed this problem with surface coatings. In this study, spinel Li4Mn5O12 was successfully prepared by wet chemical method to modify the surface of Li1.2Ni0.2Mn0.6O2. The X-ray diffraction (XRD) and X-ray photoelectron spectroscopy (XPS) test results showed that the crystal structure of the samples did not change significantly, but the cationic order was improved. The results of the scanning electron microscope (SEM), energy dispersive spectrometer (EDS), and transmission electron microscope (TEM) showed that an ultrathin spinel Li4Mn5O12 surface-modified layer with a thickness of about 10 nm was successfully constructed on the raw material surface. In addition, the lithium-ion diffusion coefficients (DLi+) of the raw materials and modified materials were calculated by electrochemical impedance spectroscopy (EIS) test and impedance fitting. The results indicated that the ultrathin Li4Mn5O12 surface modification shell can increase the lithium-ion diffusion rate of the material and improve the rate capability of the material. So, the results show that the surface modification layer of spinel Li4Mn5O12 can reduce the oxygen loss of the first cycle and improve the cationic order of the material. Therefore, the first coulombic efficiency of Li4Mn5O12/Li1.2Ni0.2Mn0.6O2 material at the current density of 12.5 mA×g-1 reaches 80.46%, and the capacity retention rate reaches 91.74% after 50 cycles, which is 3.36% and 21.23% higher than that of the raw materials, respectively. It showed better electrochemical reversibility and cyclic stability. This study provides a straightforward and convenient modification method for improving the stability of cobalt-free lithium-rich manganese cathode materials and has a favorable application prospect.

A Method for Preparing Manganese-Doped V2O5Films with Enhanced Cycling Stability

Effect of Mn2+ Doping on Structure and Electrochemical Properties of V2O5 As the Rechargeable Electrode Material

Enhanced Stability of Vanadium-Doped Li1.2Ni0.16Co0.08Mn0.56O2 Cathode Materials for Superior Li-ion Batteries

Balancing the Redox Activity Against Structure Stability in High-Voltage Manganese/iron-Based Layered Oxide Cathodes Through Copper Doping for Potassium-Ion Batteries

Nanostructured Mn-Doped V2O5 Cathode Material Fabricated from Layered Vanadium Jarosite

Aluminum doping and lithium tungstate surface coating double effect to improve the cycle stability of lithium-rich manganese-based cathode materials

Al/Mn co-doping endows V2O5•4VO2 cathode with enhanced lithium storage performance

CTAB controlled electrochemical deposition of manganese dioxide with enhanced performance in aqueous Zn-ion battery

Enhancing Cyclic Performance of Lithium-rich Manganese-based Cathode via In-situ Co-doping of Magnesium and Fluorine

Preparation of LiMn2O4 Cathode with Excellent Cycling Performance

Enhanced Cycling Performance of Spinel LiNi0.5Mn1.5O4 Cathodes through Mg-Mn Hetero-Valent Doping via Microwave Sol-Gel Method

Preparation and Characterization of M(II) and M(IV) Iso-Molar Co-Doped Li Mn_(1.9)Mg_(0.05)Ti_(0.05)O_4 Cathode Materials for Lithium-Ion Batteries

Buliding Ultrathin Li4mn5o12 Shell for Enhancing the Stability of Cobalt-Free Lithium-Rich Manganese Cathode Materials

Manipulating the Electronic Structure of Li‐Rich Manganese‐Based Oxide Using Polyanions: Towards Better Electrochemical Performance

Surface Reconstruction of High-Voltage LiNi0.5Mn1.5O4 Cathode via the Sculpture Method toward Enhanced Stability

A joint experimental and theoretical study on the effect of manganese doping on the structural, electrochemical and physical properties of lithium iron phosphate

Improved Stability of Electrochromic Devices Using Ti-doped V2O5 Film

Preparation and Electrochemical Performance of Manganese- Doped Nickel Hydroxide Cathode Materials

Understanding the Effect of Al Doping on the Electrochemical Performance Improvement of the LiMn 2 O 4 Cathode Material

Correlating Cycle Performance Improvement and Structural Alleviation in LiMn2-xMxO4 Spinel Cathode Materials: A Systematic Study on the Effects of Metal-Ion Doping

Facile pH-mediated synthesis of morphology-tunable MnCO3 and their transformation to truncated octahedral spinel LiMn2O4 cathode materials for superior lithium storage