Abstract:It is well known that a high voltage across the coupling plates of a capacitive power transfer (CPT) system is beneficial to increase its power transfer capability, but a high voltage may lead to high insulation requirements and cause safety concerns. This article proposes a compensation design method for achieving the maximum power of CPT systems under coupling voltage constraints. Based on a simplified capacitive coupling model and thorough power transfer characteristics analysis, a family of compensation topologies are derived to maintain a 90° phase shift between the input and output voltages across the CPT coupler against load variations, so that the coupling voltages (which practically need to be limited) are fully utilized for power transfer purposes. A full design process for determining the compensation parameters is presented, and an example 2-kW CPT system is built and tested using LC compensation at the primary side to boost the input voltage to the coupler; and one of the proposed compensation topologies (CLC) at the secondary side for impedance transformation of a given load with a specified voltage and power requirements. Experimental results show a good agreement with theoretical analysis, which demonstrate the phase difference between the voltages before and after the coupler is kept nearly 90°, and a maximum possible power transfer of 2.039 kW is achieved under the given voltage limits and coupling conditions. A system end-to-end (dc–dc) efficiency of 90.29% is obtained when the air gap between the coupling plates is 150 mm, and the coupling capacitance is only 13.84 pF.

Compensation Scheme for Secondary Arc Current on Four-Circuit Parallel Transmission Lines

An Adaptive Reclosure Scheme for Parallel Transmission Lines with Shunt Reactors

A Modified DC Fault Protection Scheme for Multi-Terminal HVDC Grid Based on Fault Current Limiters

Secondary Arc Parameters Characteristics of Long-distance Series Compensated Transmission Lines

Study on transient characteristics of secondary arc of AC/DC hybrid transmission lines on the same tower

Flexible Pcc Voltage Unbalance Compensation Strategy for Autonomous Operation of Parallel Dfigs

Experimental Study of Transformer Coupling SSFCL with Capacitance Load

Reliable spatial configuration strategy of fault current limiters in multi-terminal HVDC system

A New Control Strategy and Compensation Method on Hybrid System of Combining Apf with Shunt Capacitors

Distributed Capacitive Current Compensation Algorithm for Current Differential Relay of UHV Transmission Line

Simulation Research on the Effect of the Paralleled Compensating Capacitor on the Solid State Fault Current Limiter Operation

Research on an Asymmetric Fault Control Strategy for an AC/AC System Based on a Modular Multilevel Matrix Converter

A Comprehensive Coupled Methodology for Calculation and Suppression of DC Bias in UHVDC Transmission Systems

Traveling-wave Differential Relay Scheme for Double-circuit Parallel Lines on the Same Pole

Optimal Placement of Dynamic Reactive Power Compensation Devices for Improving Immunity to Commutation Failure in Multi-Infeed HVDC Systems

A Direct Power Controlled and Series Compensated EHV Transmission Line

Restriction on Secondary Arc Current on Ultra-high Voltage AC Double Circuit Transmission Lines on the Same Tower

Compensation Network Design of CPT Systems for Achieving Maximum Power Transfer Under Coupling Voltage Constraints

Active and Passive Hybrid Compensation in Nanxiang Traction Substation on Beijing-Shanghai Railway Lines

Experimental Study of Transformer Coupling Solid State Fault Current Limiter with Capacitance Load

Controlling Strategy and Implementation for Synchronously Closing 550 Kv Parallel Capacitor