Abstract:In the current paper we describe a novel sample preparation technique termed dispersive liquid-phase microextraction for the preconcentration and determination of 2,2,2-trichloro-1,1-bis(4-chlorophenyl)ethanol (dicofol) and its degradation products in water samples that includes 2-(2-chlorophenyl)-2-(4-chlorophenyl)-1,1-dichloroethene(2,4′-DDE), 1,1-dichloro-2,2-bis(4-chlorophenyl)ethane(4,4′-DDE) and 1,1,1-trichloro-2-(2-chlorophenyl)-2-(4-chlorophenyl)ethane (2,4′-DDT) coupled with gas chromatography mass spectrometry (GC-MS), in which a new ionic liquid 1,3-diisooctylimidazolium hexafluorophosphate abbreviated as [D(i-C8)IM][PF6] was used as extraction solvent. For each one extraction, 1.00 mL of the methanol solution containing 40 µL of the ionic liquid was sprayed into 25.00 mL of water sample. In the meantime the ionic liquid was finely dispersed into the aqueous phase and analytes were rapidly migrated into the ionic liquid. After the solution was centrifuged for 2 min at 5000 rpm, the droplets of the ionic liquid are subsided in the bottom of the conical test tube (30.0 ± 0.2 µL). Moreover, the factors relevant to extraction efficiencies were investigated and optimised including the volume of the ionic liquid, disperser solvent, extraction time, sample pH and ionic strength. Under optimal conditions, the enrichment factors of the extraction were between 550 and 725 with an extraction efficiency ranging from 66% to 87% for each different analyte. Finally, 1.0 µL of the ionic liquid collected from above extraction was injected into the injector block of GC-MS instrument for analysis. The detection limit (S/N = 3), the relative standard deviations for 2.0 µg L−1 of the standard analyte (n = 5) and linearity in a calibration range were found to be 3–8 ng L−1, 1.0–2.7% and 10–3000 ng L−1, respectively. Good spiked recoveries over the range of 92.0–13.5% were obtained. The proposed method offers the advantages of simplicity of operation, rapidity, good extraction efficiency and enrichment factor; it has been successfully applied to determination of dicofol and its degradation products in environmental water samples.

Voltammetric determination of hexestrol based on the enhanced effect of a polymerized 3-decyl-1-(3-pyrrole-propyl)imidazolium tetrafluoroborate ionic liquid film electrode

Determination of diethylstilbestrol and octylphenol on oxide graphene/chitosan modified glassy carbon electrode at the same time

Amperometric determination of bisphenol A in milk using ionic liquid-carbon nanotube composite electrode

Determination of methyl parathion by solid-phase extraction on an ionic liquid–carbon nanotube composite electrode

Detection of four phenolic oestrogens by a novel electrochemical immunosensor based on a hexestrol monoclonal antibody

Electrochemical Immunoassay of Estrone at an Antibody-Modified Conducting Polymer Electrode Towards Immunobiosensors

Electrochemical Sensor Based on Molecularly Imprinted Membranes at Platinum Nanoparticles-Modified Electrode for Determination of 17Β-Estradiol.

Simultaneous Determination of Phthalate Diesters and Monoesters in Soil Using Accelerated Solvent Extraction and Ultra-Performance Liquid Chromatography Coupled with Tandem Mass Spectrometry

Development of dispersive liquid-phase microextraction based on new ionic liquid 1,3-diisooctylimidazolium hexafluorophosphate as solvent for the extraction and determination of dicofol and its degradation products in water samples

Preparation and application of a novel magnetic molecularly imprinted polymer for simultaneous and rapid determination of three trace endocrine disrupting chemicals in lake water and milk samples

Ultrasensitive, Label-Free Voltammetric Detection of Dibutyl Phthalate Based on Poly-l-lysine/poly(3,4-ethylenedioxythiophene)-porous Graphene Nanocomposite and Molecularly Imprinted Polymers

Flat membrane-based electromembrane extraction coupled with UV–visible spectrophotometry for the determination of diethylhexyl phthalate in water samples

Electrochemical Determination of Estrogenic Compound Bisphenol F in Food Packaging Using Carboxyl Functionalized Multi-Walled Carbon Nanotubes Modified Glassy Carbon Electrode

Molecularly Imprinted Solid-Phase Extraction for the Selective Determination of 17Β-Estradiol in Fishery Samples with High Performance Liquid Chromatography

Voltammetry at Hexamethyl-P-Terphenyl Poly(Benzimidazolium) (HMT-PMBI)-Coated Glassy Carbon Electrodes: Charge Transport Properties and Detection of Uric and Ascorbic Acid

An Analytical Method for Estrogens in Milk Powder by Pseudo Template Imprinted Polymer Coated Fiber Coupled with Hplc

Molecular imprinted solid phase extraction combined with determination of diethylstilbestrol in environmental water samples

Determination of Volatile Water Pollutants Using Cross-Linked Polymeric Ionic Liquid as Solid Phase Micro-Extraction Coatings

The Research of Fluorescent Sensing to Endocrine Disruptor 17Β-Estradiol Measured by Microsphere Molecularly Imprinted Polymer

Constructed ILs@ Hollow Porous Spherical Ni-loaded CdFe2O4 Modified Electrode for Highly Sensitive Simultaneous Electrochemical Analysis of Bisphenols

Electrochemical Determination of Imidacloprid Using an Electrosynthesized Hexa-Peri-Hexabenzocoronene Modified Glassy Carbon Electrode (GCE) by Differential Pulse Voltammetry (DPV)