Chuanxiang Zhang,Song Li,Lingxiao Tang,Shuo Li,Changchun Hu,Dan Zhang,Long Chao,Xueying Liu,Yimin Tan,Yan Deng
Abstract:Development of an efficient technique for accurate and sensitive dibutyl phthalate (DBP) determination is crucial for food safety and environment protection. An ultrasensitive molecularly imprinted polymers (MIP) voltammetric sensor was herein engineered for the specific determination of DBP using poly-l-lysine/poly(3,4-ethylenedioxythiophene)/porous graphene nanocomposite (PLL/PEDOT−PG) and poly(o-phenylenediamine)-imprinted film as a label-free and sensing platform. Fabrication of PEDOT−PG nanocomposites was achieved through a simple liquid–liquid interfacial polymerization. Subsequently, poly-l-lysine (PLL) functionalization was employed to enhance the dispersibility and stability of the prepared PEDOT−PG, as well as promote its adhesion on the sensor surface. In the presence of DBP, the imprinted poly(o-phenylenediamine) film was formed on the surface of PLL/PEDOT−PG. Investigation of the physical properties and electrochemical behavior of the MIP/PLL/PEDOT−PG indicates that the incorporation of PG into PEDOT, with PLL uniformly wrapping its surface, significantly enhanced conductivity, carrier mobility, stability, and provided a larger surface area for specific recognition sites. Under optimal experimental conditions, the electrochemical response exhibited a linear relationship with a logarithm of DBP concentration within the range of 1 fM to 5 μM, with the detection limit as low as 0.88 fM. The method demonstrated exceptional stability and repeatability and has been successfully applied to quantify DBP in plastic packaging materials.
What problem does this paper attempt to address?
This paper aims to solve the problem of high - sensitivity and label - free voltammetric detection of dibutyl phthalate (DBP). Specifically, the authors developed an ultrasensitive voltammetric sensor based on poly - L - lysine/poly(3,4 - ethylenedioxythiophene)/porous graphene nanocomposite (PLL/PEDOT −PG) and molecularly imprinted polymer (MIP) for the specific detection of DBP.
DBP, as a commonly used plasticizer, is widely used in various applications such as food packaging, medical devices, printing inks, cosmetics and adhesives. However, because it is bound to the polymer carbon chain by weak hydrogen bonds or van der Waals forces rather than chemical bonds, DBP is easily released into the environment, contaminating water sources and food, and then enriched through the food chain, ultimately posing a threat to human health. Therefore, it is particularly important to design a method that can sensitively and accurately detect trace amounts of DBP.
The sensor proposed in the paper utilizes the combination of molecular imprinting technology and electrochemical sensing technology, which not only improves the sensitivity and selectivity of the sensor, but also simplifies the detection process. By forming a poly(3,4 - ethylenedioxythiophene) (PEDOT) conductive film on porous graphene and further using poly - L - lysine (PLL) for surface functionalization, the dispersibility and stability of the composite material are improved, and at the same time, its adhesion on the electrode surface is enhanced. In addition, by electro - polymerizing o - phenylenediamine (o - PD) on the surface of the glassy carbon electrode (GCE) modified with PLL/PEDOT −PG by cyclic voltammetry, a DBP molecularly imprinted polymer film is formed, achieving high - sensitivity and selective detection of DBP.
The research results show that under the optimal experimental conditions, the detection range of the sensor for DBP is from 1 fM to 5 μM, and the detection limit is as low as 0.88 fM, showing excellent stability and repeatability, and it has been successfully applied to the quantitative analysis of DBP in plastic packaging materials.