Abstract:Rectangular AT cut quartz resonators have been widely used in frequency control because of their smal size and extraordinary fequency temperature stability. However, a lot of spurious resonant modes such as face flexure, thickness twist, flexure and their higher order harmonics are coupled to the foundmental thickness shear mode at the edges of the plate. Traditionally only the modes propagating along the width direction are considered for two reasons. Firstly, the rectangular quartz plate dimensions used is often 2?mm×8?mm, that is, the length dimension is much larger than the width dimension. Secondly, the electrode has strong energy trap effect, which means that most of the vibration energy concentrates under the electrode. However, smaller resonators are developed recently, whose width and length dimensions are both less than 3?mm. So, it becomes necessary to take the modes propagating along both x 1 and x 3 directios into account. This paper presents the analysis of the vibration modes in AT cut quartz plate. According to Mindlin's 2 dimensional first order equations, dispersion curves for waves prorogating along x 1 and x 3 directions, in an infinite At cut quartz plate, are obtained. Moreover, after the boundary conditions are considered, standing waves are formed. Then the curves of dimensionless frqunency vs. length/thickness and width/thickness for rectangular AT cut quartz plates, i.e. mode charts, are given in this paper. There is excellent agreement between the computed results and the practical data from the factory. Finally, as an example, the design of a 4 MHz rectangular quartz resonator is shown in this paper. During the design of the resonator, the dimensions of both the width and length are carefully selected in order to avoid the existence of the spurious modes. At the same time, we can see that the computed results do not agree to the pratical data completely, especially at the high frequency range. We can improve the computed results in two ways. Firstly, because there are two correction factors in Mindlin's 2 dimensional first order equations, selecting proper correction may result in preciser mode chart. Secondly, FEM (Finite Element Method) is the desirable solution to the vibration problem of quartz resonator, because of its resilient adaptability to various boundary conditions and different cut orientations.

Energy Trapping of Thickness-Shear Modes in Inverted-Mesa At-Cut Quartz Piezoelectric Resonators

Trapped Thickness-Shear Modes in a Contoured, Partially Electroded AT-cut Quartz Resonator

Effects of Electrode off Centre on Trapped Thickness-Shear Modes in Contoured AT-Cut Quartz Resonators

Thickness-Shear Vibration Characteristics of an At-Cut Quartz Resonator with Rectangular Ring Electrodes

Variational Formulation of the Stevens-Tiersten Equation and Application in the Analysis of Rectangular Trapped-Energy Quartz Resonators

The investigation of trapped thickness shear modes in a contoured AT-cut quartz plate using the power series expansion technique

Energy trapping in high-frequency vibrations of piezoelectric plates with partial mass layers under lateral electric field excitation.

An analytical and meshless modeling for vibration analysis of an infinite quartz resonator with non-circular electrodes

Effects of Unequal Electrode Thickness, Location, and Size on Thickness-Shear Mode Quartz Piezoelectric Resonators

Variational Analysis of Thickness-Shear Vibrations of a Quartz Piezoelectric Plate with Two Pairs of Electrodes As an Acoustic Wave Filter

Thickness-shear vibration of rotated Y -cut quartz plates with unattached electrodes and asymmetric air gaps

Effects of Electrode Configuration on Vibration Characteristics of Quartz Thickness-Shear Mode Trapped-Energy Resonators

Thickness-shear Modes of an Elliptical, Contoured At-Cut Quartz Resonator

Thickness-shear Vibration of an AT-cut Quartz Resonator with a Hyperbolic Contour.

Trapped-Energy Thickness-Extensional Mode of a Partially Electroded ZnO Thin-Film Resonator

THE VIBRATION ANALYSIS AND DESIGN OF AT-CUT RECTANGULAR QUARTZ RESONATORS

Analysis of Longitudinal and Torsional Resonance Vibrations of a Piezoelectrically Excited Bar by Introducing Piezoelectric Loss Coefficients

Thickness-shear Frequencies of an Infinite Quartz Plate with Material Property Variation Along the Thickness

A New Trapped Mode Caused by Local Defect or Thermal Inhomogeneity

Study For The Quartz Resonator Force Sensor With Energy Trapping Theory

Propagation of Thickness-Twist Waves in an Infinite Piezoelectric Plate