Abstract:An accelerator driven subcritical system (ADS) is a new nuclear energy system which could not only produce clean energy but also incinerate nuclear waste. In this paper, inherent safety analysis of an ADS is performed with neutronics and thermal-hydraulics coupled code named ARTAP. Five typical accidents are carried out, including the cases of proton beam interruption, transient overpower, reactivity insertion, loss of flow, and loss of heat sink. The transient simulations are performed in the average channel and the hottest channel of the fuel pin in the ADS core. The simulation results for beam interruption show that the highest temperature of the pellet is in the middle of the fuel element in the average channel, while the peak temperature of the cladding is in the top of the fuel element. After the beam is interrupted for 20s, the maximum temperature drops at the fuel center, the cladding inner surface, and the outlet coolant in the hottest channel are 644.46K, 162.27K, and 136.42K respectively. For transient overpower accidents with the increase of beam intensity, the maximum temperature of the fuel and the cladding are below the safety limit. Concerning the reactivity insertion accident, it is found that the ADS has good inherent safety and its margin of criticality safety is large. The calculation results for loss of flow show that the power drop is small due to low sensitivity of the subcritical core to negative reactivity feedback, and the maximum temperature of the cladding reaches 1726K, which means the fuel element would rupture. However, the power and the temperatures of fuel, cladding, and coolant could decrease quickly to the safety level after the proton accelerator is cut off under a loss of flow accident. The results also show that the peak temperature of the cladding is lower than the safety limit under a loss of heat sink accident. The present simulation results reveal that the ADS has a remarkable advantage against severe accidents. It also implies that its inherent safety characteristics could ensure reactor shutdown by cutting off the proton beam after accidents occur.

Preliminary Analysis of Radiation Characteristic at Upper Section of Accelerator Driven Subcritical System

Inherent Safety Characteristics of Lead Bismuth Eutectic-Cooled Accelerator Driven Subcritical Systems

Physical Analysis of the Radiation Shielding for the Medical Accelerators

Physical Scheme Study of 10 MW Accelerator Driven Sub-critical Reactor

Radiation transport calculations for the European Spallation Source accelerator environment

Radiation Field Simulation of C-ADS Injector II

Research On Nuclear Heat Deposition Behavior In The Spallation Target Of An Accelerator Driven Subcritical System

Comparative Safety Analysis of Accelerator Driven Subcritical Systems and Critical Nuclear Energy Systems

Thermal-hydraulic analysis of LBE spallation target for accelerator-driven systems

Study on the Radiation Problem Caused by Electron Beam Loss in Accelerator Tubes

Analysis of the Accelerator-Driven System Fuel Assembly during the Steam Generator Tube Rupture Accident

Physics Design of an Accelerator for an Accelerator-Driven Subcritical System

Enhanced transmutation of minor actinides by incorporation of multi-beam design in Accelerator-Driven subcritical system

Thermal-Hydraulic Analysis Of Concept Design Of Spallation Target In Chinese Accelerator Driven Subcritical System

The Research on the Characteristics of Target and Core in a Gas-Cooled ADS with Passive Safety

Analysis for Spallation Neutron Source Induced from Proton Incident with Energy of 150 MeV

Examining the Contributions of Various Source Layers and Transport Pathways to Dose Rates Exterior to a Low- and Intermediate-Level Radioactive Waste Storage Facility Using ADVANTG/MCNP

Investigation of target in C-ADS and IAEA ADS benchmark

Thermal-Hydraulic Analysis of Spallation Target in Accelerator Driven Sub-critical System

Study of External Source Effects for Different Multibeam Concept for Accelerator-Driven Subcritical Reactor for Nuclear Waste Transmutation (ADS-NWT)

Neutronics and Thermal-Hydraulics Coupling Analysis in Accelerator-Driven Subcritical System