Abstract:The application requirements of high frame rate CMOS image sensors (CIS) in the industry have not been satisfied due to the speed limitations in traditional single-slope and serial two-step analog-to-digital converters (ADCs). In this paper, a high-speed fully differential two-step ADC design method for CIS was proposed. The proposed method was based on differential ramp and time-to-digital conversion (TDC) technology. A parallel conversion mode was formed that is different from serial conversion, and the robustness of the system was ensured due to the existence of differential ramps. Aiming at the inconsistency between traditional TDC technology and single-slope ADC, a TDC technology based on level coding was proposed. The proposed technology achieves the TDC in the last clock cycle of analog-to-digital conversion, and realized a two-step conversion process at another level. This paper presents a complete circuit design, layout design, and test verification of the proposed design method based on the 55 nm 1P4M CMOS experimental platform. Under the design environment of the analog voltage of 3.3 V, the digital voltage of 1.2 V, the clock frequency of 100 MHz, and a dynamic input range of 1.6 V, this design was a 12-bit ADC with a conversion time of 480 ns, column-level power consumption of 62 μW, differential nonlinearity (DNL) of +0.6/−0.6 LSB, and integral nonlinearity (INL) of +1.2/−1.4 LSB. Furthermore, it achieved a signal-to-noise distortion ratio (SNDR) of 70.08 dB. The proposed design provided a large area array with a high frame rate, and compared with the existing advanced single-slope ADC, its conversion speed increased by more than 52%. It provides an effective solution for the implementation of high frame frequency CIS.

Design and Simulation of an Application Specific CMOS Image Sensor

A Reconfigurable Convolution-in-Pixel CMOS Image Sensor Architecture

A 14-Bit Column-Parallel Two-Step SA ADC with On-Chip Scaled Reference Voltages Self-Calibration for CMOS Image Sensor

CMOS Image Sensor Design and Image Processing Algorithm Implementation for Total Hip Arthroplasty Surgery

A 14-Bit Column-Parallel Two-Step SA ADC with Digital Calibration Based on Scaled References and Redundancy for CMOS Image Sensors

14-Bit Column Readout Circuits with Single-to-differential PGA Using Intentional Offset and Two-Step Scaled-Reference SAR ADC for CMOS Image Sensors

A 14-bit 150KS/s SAR ADC with PGA for CMOS Image Sensor

A Multimodal Sensing CMOS Imager Based on Dual‐Focus Imaging(Adv. Sci. 14/2023)

Design Of A High Flexible Block-Based Computational Cmos Image Sensor

CMOS Image Sensor Data-Readout Method for Convolutional Operations with Processing Near Sensor Architecture.

Circuit Design of High-Dynamic-Range Image Sensor Pixel for Visual Prostheses

Design and fabrication of vertically-integrated CMOS image sensors

Compressive Acquisition CMOS Image Sensor: from the Algorithm to Hardware Implementation

Simulations and Design of a Single-Photon CMOS Imaging Pixel Using Multiple Non-Destructive Signal Sampling

CMOS Image Sensor With Area-Efficient Block-Based Compressive Sensing

High-Speed Fully Differential Two-Step ADC Design Method for CMOS Image Sensor

Microimage Processing System Based On Cmos Sensor

Architecture Of Three Dimensional Compressive Acquisition Cmos Image Sensor

Compensation for Process and Temperature Dependency in a CMOS Image Sensor

An area‐effective and low‐power single‐slope ADC for DCG imaging CMOS image sensor

Image Acquisition System Using On Sensor Compressed Sampling Technique