Pressure Sensors: Working Principles of Static and Dynamic Calibration

José Dias Pereira

DOI: https://doi.org/10.3390/s24020629

IF: 3.9

2024-01-19

Sensors

Abstract:This paper starts with an overview of the main principles used for pressure measurements, focusing on their usage in industrial applications' domains. Then, the importance of calibration procedures, namely, static and dynamic calibration of pressure sensors, is analyzed. Regarding calibration, it is important to note that there are several applications where the pressure signals to be measured can have large variations in short periods of time. In industrial applications, particularly in continuous production processes, generally, dynamic pressure measurements are less common; however, they are still required in several cases, such as control loops that are very sensitive to pressure variations, even if the frequencies of those variations are in the range of a few tens of hertz, or even lower. The last part of the paper presents the hardware and software of a flexible and low-cost static and dynamic pressure calibrator that also presents the capability to generate arbitrary waveform pressure signals for calibration and testing purposes. The proposed calibrator also includes the following advantages: remote pressure sensing capabilities that can be used to minimize calibration errors, such as those associated with capillary effects and pressure leakages; portability; and low cost. The paper ends with some experimental results obtained with the proposed calibrator.

engineering, electrical & electronic,chemistry, analytical,instruments & instrumentation

What problem does this paper attempt to address?

The main problems that this paper attempts to solve are the key issues in the static and dynamic calibration of pressure sensors. Specifically:

1. **Static calibration**: In many industrial applications, static calibration is usually sufficient. However, in some specific application scenarios, such as centrifugal pump blade fracture detection and pressure fluctuation monitoring in the headbox of a paper machine, static calibration may not meet the high - precision requirements. Therefore, the paper explores the limitations and necessity of static calibration.

2. **Dynamic calibration**: In some cases, dynamic pressure measurement is essential. For example, in situations where the control loop is very sensitive to pressure changes, or in fields such as gas turbine testing, internal combustion engine testing, and biomedical applications, accurate measurement of dynamic pressure signals is required. The paper analyzes in detail the importance of dynamic calibration and discusses the challenges faced by dynamic calibration, such as pipe effects and temperature influences.

3. **Design and implementation of calibration equipment**: The paper proposes a flexible and low - cost static and dynamic pressure calibrator. This calibrator has the ability to generate pressure signals of arbitrary waveforms and can be used for calibration and testing purposes. In addition, this calibrator also has a remote pressure sensing function, which can reduce calibration errors caused by capillary effects and pressure leakage. The paper also shows the results of experiments using this calibrator, verifying its effectiveness and reliability.

In summary, this paper aims to analyze the static and dynamic calibration principles of pressure sensors and propose an improved calibration method and equipment to improve the accuracy and reliability of pressure measurement.