Abstract:This article presents a direct synthesis method for the design of a wideband filtering switch, where p-i-n diodes are incorporated into each resonator. As parasitic parameters are embedded in the p-i-n diodes, an ideal transformer is introduced in each resonator to provide the freedom to designate the proper values for inductances and capacitances in the resonators. According to the rejection specification in the on state, an $N$ th order bandpass filter (BPF) network with $N$ transmission zeros (TZs) is synthesized, followed by a new circuit model extraction procedure to extract lumped circuits in the BPF network. To simplify the network topology, two ideal transformers at input–output port remain after absorbing the ideal transformers between resonators. Then, the lumped circuit model is converted into a distributed circuit model in the synthesis process, maintaining the filtering response in a wide frequency range when the switch is in the on state. Besides, the $N$ TZs of the filtering switch in the off state can be introduced and arranged to suitable positions. Consequently, high isolation within the stopband of the switch in the off state can be achieved. For demonstration purposes, two filtering switches with fractional bandwidths (FBWs) of 30% and 50% are fabricated and measured. Good agreement can be observed between the simulated and measured results, which validates the feasibility of the proposed method.

Sharp Skirt Bandpass Filter-Integrated Single-Pole Double-Throw Switch with Absorptive OFF-State

3D Heterogenous Integrated Wideband Switchable Bandpass Filter Bank for Millimeter Wave Applications

0.8/2.2-GHz Programmable Active Bandpass Filters in InP/Si BiCMOS Technology

A 5th order 0.8/2.4 GHz programmable active band pass filter for power DAC applications

A 0.8/2.4 GHz Tunable Active Band Pass Filter in InP/Si BiCMOS Technology

Compact dual-band bandpass filter using asymmetrical dual stub-loaded open-loops

Design of A Reconfigurable Filtering Switch with Sharp Rejection and Wide Stopband

A Wideband Filtering Switch: Its Synthesis and Design

Sharp Roll-Off Bandpass Filter Using Coupled Lines and Stepped-Impedance Stubs

Tunable Bandpass Filter Using a Switched Tunable Diplexer Technique.

Switchable Frequency Selective Surfaces Absorber/reflector for Wideband Applications

Design of a Switchable Filter for Reflectionless-Bandpass-to-Reflectionless-Bandstop Responses

Switchable Rasorber/Absorber Based on PIN Diodes

A Compact Bandpass Filter with Active Switchable Passband Status

Compact Microstrip Bandpass Filter with Sharp Roll-off and Broad Stopband Using Modified 0° Feed Structure

High Selectivity Seventh-Order Wideband Bandpass Filter Using Coupled Lines and Open/shorted Stubs

Design and simulation of tunable bandstop filters by integrating RF MEMS shunt switch for K-band applications

High Selectivity Wideband Bandpass Filter Based on Stepped Impedance Open Stubs Loaded Ring Resonator

A Compact Sharp Roll-Off Microstrip Lowpass Filter With Ultra-Wide Stopband

Compact Dual-Band Bandpass Filter Using Stub-Loaded Stepped Impedance Resonators with Mixed Electric and Magnetic Couplings