Abstract:Co-firing semicoke and coal in utility boilers is a promising approach to cleanly and efficiently utilize semicoke, while the co-combustion characteristics have yet to be fully understood, including the effects of the blending method and secondary air distribution mode on NOx emission and combustion efficiency. In the present work, both full-scale experiments and simulation were carried out to investigate the co-combustion characteristics of semicoke and coal in a 300 MW coal-fired utility boiler with a focus on the blending method and air distribution. The results indicated that co-firing semicoke would reduce the furnace temperature and that both NOx emission and incomplete combustion heat loss increased with the blending amount of semicoke. Hence, to limit the excessive deterioration of boiler performance, the blending amount of semicoke was recommended to be below 50% for the in-furnace blending method and below 33% for the out-furnace blending method. When the in-furnace blending method was employed, the semicoke and coal were recommended to be fed from burners in alternate layers, in particular, without semicoke fed from the top and/or bottom burners. The NOx emission was proved to positively correlate with the average height of semicoke burners, while the burnout ratio increased at first and then decreased with the increasing average height. The in-furnace blending method with optimal burner allocation was proved to have advantage over the out-furnace blending method. The secondary air distribution of the pagoda down type could reduce NOx generation and unburned carbon due to the formation of a high-temperature and strong reducing atmosphere within the furnace.

Online Blend-Type Identification During Co-Firing Coal and Biomass Using SVM and Flame Emission Spectrum in a Pilot-Scale Furnace

Combining Flame Monitoring Techniques and Support Vector Machine for the Online Identification of Coal Blends

A fast method of on-line coal identification in a drop-tube furnace

Support Vector Machine Based Online Coal Identification Through Advanced Flame Monitoring

On-line Tracking of Pulverized Coal and Biomass Fuels Through Flame Spectrum Analysis

Biomass Fuel Identification Based on Flame Spectroscopy and Feature Engineering

Investigations into the Ignition Behaviors of Pulverized Coals and Coal Blends in a Drop Tube Furnace Using Flame Monitoring Techniques

Ignition Characteristic of Blended Coal in a Drop-Tube Furnace

Numerical Study of Co-firing Biomass with Lean Coal under Air–Fuel and Oxy-fuel Conditions in a Wall-Fired Utility Boiler

Investigation of ash fusion characteristics on co-combustion of coal and biomass (straw, sludge, and herb residue) based on experimental and machine learning method

Coal-fired power plant boiler combustion process modeling based on support vector machine and load data division

Numerical Simulation of the Synergistic Effect of Combustion for the Hydrochar /coal Blends in a Blast Furnace

Experiments and Simulation on Co-Combustion of Semicoke and Coal in a Full-Scale Tangentially Fired Utility Boiler

Modeling the co-combustion of bi-fuel blends in a drop tube furnace: A numerical approach

A DNS Study on Temporally Evolving Jet Flames of Pulverized Coal/biomass Co-Firing with Different Blending Ratios

Online Combustion Status Recognition of Municipal Solid Waste Incineration Process Using DFC Based on Convolutional Multi-Layer Feature Fusion

Multi-objective modeling of boiler combustion based on feature fusion and Bayesian optimization

Numerical Analysis on Effect of Blend Ratio on Co-Combustion Characteristics of Semi-Coke and Bituminous Coal in Swirl Burner

Combustion interactions in oxy-fuel firing of coal blends: An experimental and numerical study

Study And Application Of Two-Level Optimization Of Coal Blending For Power Plant Based On On-Line Coal Identification

SVM-based multisensor data fusion for phase concentration measurement in biomass-coal co-combustion