Abstract:The advancements in network technologies and the evolution of the Internet of Things (IoT) have made supporting industrial control systems over probabilistic data networks promising. However, control systems’ communication over the traditional data networks is faced with problems of instability in feedback control and poor quality of performance due to time-varying data propagation delay. This paper presents two approaches that can enable real-time industrial control over non-deterministic computer networks allowing control system designers to take advantage of the existing communication infrastructures. The first approach is based on system-level interaction over two wires network called the collaboration network. The second approach is based on the implementation of the virtual local area network (VLAN). This method allows real-time control of industrial equipment or systems over IP-based networks while other computers are connected. Nodes providing real-time control services have the same PortID on the VLAN switch. This approach minimizes data traffic and reduces time-varying delay in system control over IP networks. The first approach was modeled and simulated using Proteus ISIS software. Two PIC16F877A microcontrollers were used to represent two nodes. CISCO packet tracer was used in the second approach to model and simulate IP-based control system communications over the traditional data network. Results indicate that the use of a two-wire collaborative network approach to a real-time control system is effective but requires an additional network alongside the main data traffic channel. VLAN, therefore, presents a more flexible approach that relies on the same infrastructures.

A Network Interface Device for Networked Control System with Time-Driven Mode

Tree-Based Intermittent Connection Fault Diagnosis for Controller Area Network

EPA-based Open Network Control System

Real-time scheduling scheme for EPA networks

Design and Test of Hardware-in-the-loop Platform for Vehicle Chassis CAN System with Intermittent Open and Short Connection Faults

Networked Control System Design and Implementation

Design and FPGA Verification of a Novel Reliable Real-Time Data Transfer System

Design And Evaluation Of Event-Driven Networked Realtime Control Systems With Iec Function Blocks

NDNVIC: Named Data Networking for Vehicle Infrastructure Cooperation.

An interface designed for networked monitoring and control in wireless sensor networks

A time‐triggered control network for industrial automation

Online Real-Time Estimation of Response Time for Periodic Messages in Controller Area Networks

A Novel Auto-Tuning Robust Pid Controller for Networked Control System

CaaS: Enabling Control-as-a-Service for Time-Sensitive Networking.

Data communications network for real-time industrial control systems

A Delay-tolerant, Potential Field-Based, Network Implementation of an Integrated Navigation System

Satellite Onboard Tele-Command And Telemetry Control System Based On Control Area Network (Can)

Intelligent Control Network Design Based on CAN-bus for Audio Equipment

Incorporate design of on-board network and inter-satellite network

A Delay Based Plug-in-Monitor for Intrusion Detection in Controller Area Network.

Development of Deterministic Communication for In-Vehicle Networks Based on Software-Defined Time-Sensitive Networking