Chitosan-based Polymer Gel Paper Actuators Coated with Multi-Wall Carbon Nanotubes and MnO2 Composite Electrode

Zhuangzhi Sun,Wenlong Song,Gang Zhao,Haojun Wang
DOI: https://doi.org/10.1007/s10570-017-1416-5
IF: 6.123
2017-01-01
Cellulose
Abstract:In this work, MCNT/MnO2 composite electrode actuators were fabricated by ultrasonic oscillating adsorption of MnO2 on both sides of the MCNT coated chitosan membrane. Elemental composition determined by an energy-dispersive spectrometer showed that the doping MnO2 was successfully adsorbed on the surface of MCNT. Surface morphologies of actuators under different doping MnO2 ratios (0, 0.1, 0.25, 0.5, 1) were characterized using scanning electron microscopy. The electromechanical properties of actuators were further given by the experimental test platform, and the electrochemical properties of actuators were analyzed using cyclic voltammetry (CV). CV results revealed that the changing trends of specific capacitance and output force density, specific capacitance and strain were basically the same. When the ratio of MnO2 was less than 0.5, the former performance increased rapidly, while higher than 0.5, the latter grew faster. The experimental results showed that the adsorption content of MnO2 particles was affected by changing the conductivity of the electrode layer, which affected the electromechanical properties of actuators.
What problem does this paper attempt to address?