Abstract:Columns of overpasses are highly exposed to the potential hazard of vehicular collisions. This type of collisions occurred in the past, sometimes with catastrophic consequences. Previous research reported in the literature has explored the dynamic response of RC column under impact loading using both numerical and experimental methods. The majority of the available tests were performed on horizontal elements featuring beam characteristics. In this context, a new facility for the testing of vertical elements featuring the real characteristics of RC columns was realized in the Collision Laboratory of Nanjing Tech University. Four impact tests on cantilever circular RC column were conducted using this facility. The diameter of the column is 330 mm and the height is 1700 mm The column is a one-third scaled model of a 5.2 m tall RC bridge pier. All the columns have the same configuration of the longitudinal reinforcement bars and two different hoop spacings both representing the case of a low shear reinforced structural element. Impact force, lateral displacements and accelerations were measured. A high-speed camera was adopted to record the evolution of the damage of the RC column during the impact. A brittle shear-type damage was observed characterized by one main diagonal crack located from the rear base of the column to the base of the impact point. Finally, a numerical study was also conducted using LS-DYNA showing a good agreement with the experimental results, especially in the low-velocity impacts. Results highlighted the vulnerability of these structural elements under impact loading. (C) 2017 The Authors. Published by Elsevier Ltd.

The Microscopic Study of Adiabatic Shear Bands of Comp.B Explosive Column under Impact

Adiabatic Shear Fractures and Fragments of Cylindrical Structures under Internal Explosive Loading

Experimental and Numerical Study on the Behavior of Circular RC Columns under Impact Loading

Impact response and damage evolution of triaxial braided carbon/epoxy composites. Part I: Ballistic impact testing

Dynamic Analysis of Structural Columns Subjected to Impulsive Loading

Investigation on Damage Mechanism of RC Column under Close-in Explosion

Study on Microstructures and Damage Evolution of a Substitute of Polymer Bonded Explosive

Experimental Investigation to the Damage Localization of PBX Mechanical Failure at Mesoscale

Experimental Study on the Microstructures and Dynamic Behavior of a PBX Substitute Material

Multiple Adiabatic Shear Bands in Ti–6Al–4V Targets under Ballistic Impact

Damage in Carbon Fiber/epoxy Resin Composites under Explosive Impact

A Study On The Behavior Of Adiabatic Shear Bands In Impact Wear

Investigation of the twin-induced adiabatic shear bands evolution in a Mg-Al-Mn alloy under ballistic impact

Study of spontaneous adiabatic shear bands in expanding rings under explosion by thermo-elastic-plastic phase field model

Dynamic behavior and adiabatic shearing formation of the commercially pure titanium with explosion-induced gradient microstructure

Mechanism of Microscopic Fracture of Typical Shell Steel under Impact Loading

Dynamic Response and Microstructure Evolution of Ta-2.5W and Cu Under Detonation Loading

Transient Failure Process of Explosion Containment Vessels Subjected to Adiabatic Shear

Experimental Study on the Localized Deformation and Damage Behavior of Polymer-Bonded Explosive Simulant under Cyclic Compression

The Effects of Microstructure on the Dynamic Mechanical Response and Adiabatic Shearing Behaviors of a Near-α Ti-6Al-3Nb-2Zr-1Mo Alloy

Experimental on the Microstructure Changing of Emulsion Explosives under Dynamic Pressure