Effects of mixing ratio and injection timing on combustion and emissions of DME-ethanol engine

tang qing,qiao xinqi,li pengfei,wang chunhai,huang zhen

DOI: https://doi.org/10.13738/j.issn.1671-8097.2017.05.011

2017-01-01

Abstract:Effects of ethanol nixing ratio and injection timing on the combustion and emission characteristics of DME(dimethyl ether)-ethanol blend were experimentally investigated on an electronically controlled common rail engine. The results show that increasing ethanol proportion leads to ignition delay extending,combustion duration shortening,and maximum pressure rise rate increasing.With the delay of injection,ignition delay increases and the combustion phase is delayed. The duration of the combustion is prolonged when the pure DME is extended but first extends and then shortens for mixed fuel,along with the maximum pressure rising rate first decreasing and then increasing. Mixing ethanol and retarding injection timing increase the proportion of premixed combustion. With injection timing retarding,exhaust temperature of blended fuel increases. When injection timing beyond top dead center,exhaust temperature increases with ethanol proportion increasing. High exhaust temperature with enormous energy contributes to large pressure ratio of the turbocharger and large intake flow rate,which leads to in-cylinder compression pressure increasing. With injection timingprior to top dead center,mixing ethanol keeps HC and CO emissions at a low level while reducing NO_xemissions to a certain extent. NO_xemissions are reduced by 11% with 15% ethanol mixing ratio. By retarding fuel injection,NO_xemissions decrease up to 52%. However,with fuel injection excessively retarded,NO_xemissions of15% ethanol blended fuel are higher than those of pure DME due to lower thermal efficiency and higher cyclic injection quantity. HC and CO emissions increase first slowly and then rapidly with the injection timing retarding.