Abstract:The steam heating pipeline, as a heat energy delivery method, plays an important role in petrochemical, food processing, and other industrial fields. Research on dynamic hydraulic and thermal calculation methods for steam heating pipelines is the basis for the realization of precise control and efficient operation of steam pipe networks, which is also the key to reducing the energy consumption and carbon emissions of urban heating. In this study, the coupled hydraulic–thermal model of a steam pipeline is established considering the steam state parameter changes and condensate generation, the SIMPLE algorithm is used to realize the model solution, and the accuracy of the model is verified by the actual operation data of a steam heat network. The effects of condensate, environmental temperature, and steam pipeline inlet temperature and pressure changes on the hydraulic and thermal characteristics of the steam pipeline are simulated and analyzed. Results indicate that condensate only has a large effect on the steam outlet temperature and has almost no effect on the outlet pressure. As the heat transfer coefficient of the steam pipeline increases, the effect of both condensate and environmental temperature on the steam outlet temperature increases. The effect of the steam inlet pressure on the outlet pressure is instantaneous, but there is a delay in the effect of the inlet temperature on the outlet temperature, and the time required for outlet temperature stabilization increases by about 25 s to 30 s for each additional 400 m of pipeline length. The research can be applied to the control of supply-side steam temperature and pressure parameters in actual steam heating systems. Utilizing the coupled hydraulic–thermal characteristics of the steam pipeline network, tailored parameter control strategies can be devised to enhance the burner's combustion efficiency and minimize fuel consumption, thereby significantly augmenting operational efficiency and fostering sustainable development within the steam heating system.

Simulation Test and Research on the Heating System for Heavy Oil Tank Cars

Research on Cylinder Head Thermal State Simulation

Simulation and Experimental Study on Thermal State of Engine Compartment of Commercial Vehicle

Experimental Study and Simulation Principles of an Oil-Gas Multiphase Transportation System

Simulation of diesel fuel heating under transient high pressure

Simulation on the Lubrication System of Diesel Engine

Experiment and Simulation on a Thermal Management Scheme of Intermediate Circulation Based on Heat Current Method

EXPERIMENTAL STUDY AND NUMERICAL SIMULATION OF TWO-STAGE OIL-LESS IGNITION SYSTEM

The Research and Application of Computer Simulation on Heat Treatment in China

Infrared Radiation Calculation and Simulation of Exhaust Smoke for Armored Vehicle

Research on Hybrid Modeling Simulation Method of Steam Dynamic Transmission and Distribution Process

Applied Research of Solar Energy for Heating Crude Oil of Transportation

Analysis of heat transfer characteristics of paraffin oil in oil tank based on the three-phase partition method

Research on Modeling and Simulation of Hydraulic Oil Supply System with Pressurized Tank Based on AMESet

Theoretical Insight into the Effect of Steam Temperature on Heavy Oil/Steam Interface Behaviors Using Molecular Dynamics Simulation

Analysis on Heat Transfer and Steam Injection in the Wellbore and Calculation on Heat Loss

Heat Transfer Simulation Study of Hot Oil Tubes Based on COMSOL

Simulation of Coupled Hydraulic–Thermal Characteristics for Energy-Saving Control of Steam Heating Pipeline

Research on thermal radiation response of large crude oil tank based on numerical simulation method

Three-Dimensional Physical Simulation of Heavy Oil Exploitation by Hot Solvent Injection

Numerical Simulation of Heat Treatment and Its Remote Technical Service