Abstract:Concerns about arsenic emission issues are growing as the arsenic discharged from coal-fired power plants seriously endangers the ecological environment and public health. The gas-phase arsenic capture by a CaO–Ca12Al14O33 synthetic sorbent at 1000–1200 °C in the simulated flue gas was conducted, with the influence of the addition ratio of Ca12Al14O33, temperature, retention time, and acid gases NO/SO2 considered in the study. The results indicated that the synthetic sorbent containing 15 wt % Ca12Al14O33 (Ca85Al15) exhibited much better arsenic adsorption performance than CaO, which was ascribed to the greatly strengthened sintering resistance of CaO particles by adding Ca12Al14O33, enabling arsenic adsorption and chemical reactions. Both the increasing temperature and retention time facilitated arsenic adsorption by Ca85Al15, and the hypertoxic arsenic vapor (As3+) was converted into arsenate (Ca3(AsO4)2) with less toxicity. In the presence of NO, the arsenic capture was gradually suppressed with increasing retention time. On the other hand, SO2 could slightly facilitate the capture of arsenic at 1000–1100 °C for 10 min; nevertheless, due to the formation of Ca4Al6O12SO4, the promotion effect was inhibited at a higher temperature and a longer retention time. In general, the study provided a basis for developing highly efficient solid sorbents toward controlling arsenic vapor emission derived from coal combustion, and the appropriate conditions for arsenic capture were at 1000–1100 °C.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acs.energyfuels.0c03686?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acs.energyfuels.0c03686</a>.Schematic illustration of the preparation procedure to synthesize CaO–Ca12Al14O33 (Figure S1) and diagrams of the adsorption–desorption isotherms of Ca85Al15 and pore-size distribution curves of CaO and synthetic sorbents with different CaO/Ca12Al14O33 ratios based on BJH adsorption data (Figure S2) (<a class="ext-link" href="/doi/suppl/10.1021/acs.energyfuels.0c03686/suppl_file/ef0c03686_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

Adsorption and reaction mechanism of arsenic vapors over γ-Al2O3 in the simulated flue gas containing acid gases.

Deep insight into the effect of NaCl/HCl/SO2/CO2 in simulated flue gas on gas-phase arsenic adsorption over mineral oxide sorbents

Insight into High Temperature Gas-Phase Arsenic Capture by a CaO–Ca 12 Al 14 O 33 Synthetic Sorbent

Enhanced Adsorption of Trivalent Arsenic from Water by Functionalized Diatom Silica Shells.

Microscopic Spherical α-Fe 2 O 3 for Highly Efficient Gaseous Arsenic Capture in Simulated Flue Gas Under a Wide Temperature Range

Experiment and mechanism research on gas-phase As2O3 adsorption of Fe2O3/γ-Al2O3

Microscopic Spherical Α-Fe2o3 for Highly Efficient Gaseous Arsenic Capture in Simulated Flue Gas under a Wide Temperature Range

Stable and Efficient As2O3 Removal from Simulated Flue Gas Using Al2O3/CaSiO3 Prepared by Anhydrous Grinding and Calcination Method

Gaseous Arsenic Capture in Flue Gas by CuCl 2 -Modified Halloysite Nanotube Composites with High-Temperature NO x and SO x Resistance

Progress of gaseous arsenic removal from flue gas by adsorption: Experimental and theoretical calculations

As2O3 Adsorption Enhancement over Ni-modified Γ-Al2o3 in Complex Flue Gas Constituents

Simultaneous Removal of So2 and Trace As2o3 from Flue Gas: Mechanism, Kinetics Study, and Effect of Main Gases on Arsenic Capture

Effects of 10alpha,25-dihydroxyvitamin D3 on doxorubicin-induced chromosomal aberrations in rat bone marrow cells.

Arsenic Adsorption Enhancement Performances of Mn-modified Γ-Al2o3 with Flue Gas Constituents Involved.

A deep insight into the role of O2 on As2O3 capture over γ-Al2O3 sorbent: Experimental and DFT study

As2O3 capture from incineration flue gas by Fe2O3-modified porous carbon: Experimental and DFT insights

Insight into As2O3 adsorption characteristics by mineral oxide sorbents: Experimental and DFT study

Strengthened arsenic adsorption over Ni-modified gamma-Al2O3 under different operation conditions: An experimental and simulation study

Experimental and theoretical study of arsenic removal by porous carbon from MSW incineration flue gas

Chemically bonded zirconium oxide into CaO-based high-temperature coal-fired flue gas As 2 O 3 absorbents for enhanced anti-sintering properties: Experimental and DFT study

The role of SO2 in arsenic removal by carbon-based sorbents: A DFT study