Abstract:The present report describes the preparation and characterization of large-bore particle-entrapped monolithic precolumns, which are suitable for incorporation into a two-dimensional liquid chromatography (2D-LC) system for proteome analysis. The fritless precolumns with different inner diameter (i.d.) (320 and 530μm) were rapidly and successfully prepared by entrapping octadecylsilica (ODS) particles (5μm, 300Ǻ) prepacked into fused silica capillaries with a sol–gel network, which was formed by hydrolysis and polycondensation of methyltriethoxysilane (MTES). By optimizing the composition of the sol solution, the resulting large-bore monolithic precolumns of 5mm length allow a flow rate of 20μL/min loading buffer at a reasonable low back pressure of 25bar or less and are capable of withstanding up to 300bar inlet pressure. Scanning electron micrograms of the precolumns profile showed that the evolving sol–gel network joined particles to each other and onto the column wall, and no cracking or shrinkage of the column bed was observed even in 530μm-i.d. capillary. The performance of the particle-entrapped monolithic precolumns used for preconcentration and desalting of proteolytic digest was evaluated by on-line coupling the large-bore precolumns with a capillary reversed-phase liquid chromatographic (RPLC) column followed by UV detection. The laboratory-made monolithic precolumns with 320 and 530μm i.d. were characterized by using BSA tryptic digest or peptide standards as the analytes with respect to sample loading capacity, linearity, recovery and reproducibility, etc. The results indicate that the large-bore and short precolumns (5mm×320μm i.d. or 5mm×530μm i.d.) allow sample fast loading at a flow rate of 30 or 60μL/min. The precolumns also have a mass loading capacity for BSA peptides of about 70μg and for standard peptides of about 80μg. Good linear calibration curves (R2>0.99) were obtained and the limits of detection (signal-to-noise ratio, S/N=3) were improved by more than 60-fold and were between 0.53 and 1.32ng/μL even with a UV absorbance detector. The total recovery was found to be approximately 90–100% for BSA digest and standard peptides. The day-to-day relative standard deviation (RSD) values for recoveries of BSA peptides on a single precolumn ranged from 4.66 to 7.56% and 2.68 to 3.05% for precolumn back pressure, while the column-to-column RSD values were 3.51–6.13% and 1.22–1.26% for recoveries of BSA peptides and precolumn back pressure, respectively. With good precolumn reproducibility, no significant degradation or decrease in precolumn performance was showed even after ∼150 preconcentration/desorption cycles. The precolumns also proved to be resistant to salt buffer with high concentration and low-pH mobile phase. The large-bore particle-entrapped monolithic precolumns will be further used in a high-throughput 2D-LC array system coupled with tandem matrix assisted laser desorption/ionization-time of flight–time of flight–mass spectrometry (MALDI-TOF–TOF–MS) detection for proteome analysis.

Functionalization of Hybrid Monolithic Columns Via Thiol-Ene Click Reaction for Proteomics Analysis.

Fast Fabrication and Modification of Polyoctahedral Silsesquioxane-Containing Monolithic Columns Via Two-Step Photo-Initiated Reactions and Their Application in Proteome Analysis of Tryptic Digests

C18-Functionalized Amine-Bridged Hybrid Monoliths for Mass Spectrometry-Friendly Peptide Separation and Highly Sensitive Proteomic Analysis

Facile Preparation of Multi-Functionalized Hybrid Monoliths Via Two-Step Photo-Initiated Reactions for Two-Dimensional Liquid Chromatography–mass Spectrometry

Preparation and characterization of hydrophilic hybrid monoliths via thiol-ene click polymerization and their applications in chromatographic analysis and glycopeptides enrichment.

Preparation of polyhedral oligomeric silsesquioxane-based hybrid monolith by ring-opening polymerization and post-functionalization via thiol-ene click reaction.

Surface-Charged Hybrid Monolithic Column for MS-Compatible Peptide Separation with High Peak Capacity and Its Application in Proteomic Analysis

Preparation of Monolithic Polymer Columns with Homogeneous Structure Via Photoinitiated Thiol-Yne Click Polymerization and Their Application in Separation of Small Molecules.

Fast Preparation of Hybrid Monolithic Columns Via Photo-Initiated Thiol-Yne Polymerization for Capillary Liquid Chromatography

Modification of VTMS hybrid monolith via thiol-ene click chemistry for capillary electrochromatography.

Octadecylated Silica Monolith Capillary Column With Integrated Nanoelectrospray Ionization Emitter For Highly Efficient Proteome Analysis

Ethane-Bridged Hybrid Monolithic Column with Large Mesopores for Boosting Top-Down Proteomic Analysis

Preparation of Hybrid Monolithic Columns Via "One-Pot" Photoinitiated Thiol-Acrylate Polymerization for Retention-Independent Performance in Capillary Liquid Chromatography

One-Pot Approach to Prepare Organo-silica Hybrid Capillary Monolithic Column with Intact Mesoporous Silica Nanoparticle As Building Block

Preparation of a long-alkyl-chain-based hybrid monolithic column with mixed-mode interactions using a "one-pot" process for pressurized capillary electrochromatography.

Synthesis of Sulfo/vinyl Biphasic Silica Hybrid Monolithic Capillary Column and Its Application to On-Column Preconcentration for Capillary Electrochromatography.

Large-Bore Particle-Entrapped Monolithic Precolumns Prepared by A Sol-Gel Method for On-Line Peptides Trapping and Preconcentration in Multidimensional Liquid Chromatography System for Proteome Analysis

Facile preparation of organic-silica hybrid monolith for capillary hydrophilic liquid chromatography based on " thiol-ene" click chemistry

"One-pot" process for fabrication of organic-silica hybrid monolithic capillary columns using organic monomer and alkoxysilane.

Automation of Nanoflow Liquid Chromatography-Tandem Mass Spectrometry for Proteome and Peptide Profiling Analysis by Using A Monolithic Analytical Capillary Column

Facile Construction of Macroporous Hybrid Monoliths Via Thiol-Methacrylate Michael Addition Click Reaction for Capillary Liquid Chromatography.