Ethane-Bridged Hybrid Monolithic Column with Large Mesopores for Boosting Top-Down Proteomic Analysis

Chao Wang,Yu Liang,Baofeng Zhao,Zhen Liang,Lihua Zhang,Yukui Zhang

DOI: https://doi.org/10.1021/acs.analchem.1c05234

IF: 7.4

2022-04-12

Analytical Chemistry

Abstract:Top-down proteomics is challenged by the high complexity of biological samples. The coelution of intact proteins results in overlapped mass spectra, and hence, an increased peak capacity for protein separation is needed. Herein, ethane-bridged hybrid monoliths with well-defined large mesopores were successfully prepared based on the sol–gel condensation of 1,2-bis(trimethoxysilyl)ethane and tetramethoxysilane, followed by two-step base etching of the Si–O–Si domain while maintaining the Si–C–C–Si domain in the structure. Relatively homogeneous macropores of 1.1 μm and large mesopores of 24 nm were obtained, permitting fast mass transfer of large molecules and efficient diffusion without obstruction. The use of less hydrophobic C1 ligand further sharpened the peak shape and improved peak capacity. A 120 cm-long capillary column was used for top-down proteomic analysis of E. coli lysates under low backpressure with 16 MPa. High peak capacity of 646 was achieved within 240 min gradient. With MS/MS analysis, 959 proteoforms corresponding to 263 proteins could be unambiguously identified from E. coli lysates in a single run. Furthermore, to illustrate the separation performance for large proteoforms, such monoliths were applied to top-down analysis of the SEC fraction of E. coli lysates with Mw ranging from 30 to 70 kDa. With highly effective separation, 347 large proteoforms with Mw higher than 30 kDa were detected in the single 75 min run. These results showed great potential for top-down proteomic analysis in complex samples.The Supporting Information is available free of charge at https://pubs.acs.org/doi/10.1021/acs.analchem.1c05234.Figures S1–S5 and Table S1(PDF)This article has not yet been cited by other publications.

chemistry, analytical