Softening, Conformable, and Stretchable Conductors for Implantable Bioelectronics Interfaces
Pedro E. Rocha‐Flores,Chandani Chitrakar,Ovidio Rodriguez‐Lopez,Yao Ren,Alexandra Joshi‐Imre,Ankit R. Parikh,Ahmet S. Asan,James R. McIntosh,Aldo Garcia‐Sandoval,Joseph J. Pancrazio,Melanie Ecker,Hongbing Lu,Jason B. Carmel,Walter E. Voit
DOI: https://doi.org/10.1002/admt.202401047
IF: 6.8
2024-12-05
Advanced Materials Technologies
Abstract:This study presents a material‐design‐processing combo for stretchable conductors and implantable devices to enhance communication between the body and external electronics. Results show improved conformability and stretchability with stable electrical performance. Electrical resistance remained below 1.5× initial resistance at 150% strain and after 10 000 fatigue cycles. Additionally, these optimized conductors are demonstrated in an animal spinal cord stimulation device. Neural implantable devices serve as electronic interfaces facilitating communication between the body and external electronic systems. These bioelectronic systems ideally possess stable electrical conductivity, flexibility, and stretchability to accommodate dynamic movements within the body. However, achieving both high electrical conductivity and mechanical compatibility remains a challenge. Effective electrical conductors tend to be rigid and stiff, leading to a substantial mechanical mismatch with bodily tissues. On the other hand, highly stretchable polymers, while mechanically compatible, often suffer from limited compatibility with lithography techniques and reduced electrical stability. Therefore, there exists a pressing need to develop electromechanically stable neural interfaces that enable precise communication with biological tissues. In this study, a polymer that is softening, flexible, conformal, and compatible with lithography to microfabricate perforated thin‐film architectures is utilized. These architectures offer stretchability and improved mechanical compatibility. Three distinct geometries are evaluated both mechanically and electrically under in vitro conditions that simulate physiological environments. Notably, the Peano structure demonstrates minimal changes in resistance, varying less than 1.5× even when subjected to ≈150% strain. Furthermore, devices exhibit a maximum mechanical elongation before fracture, reaching 220%. Finally, the application of multi‐electrode spinal cord leads employing titanium nitride for neural stimulation in rat models is demonstrated.
materials science, multidisciplinary