Abstract:A unique transformation of WO3 nanowires (NW-WO3) into hexagonal prisms (HP-WO3) was demonstrated by tuning the temperature of the (N2H4)WO3 precursor suspension prepared from tungstic acid and hydrazine as a structure-directing agent. The precursor preparation at 20 °C followed by calcination at 550 °C produced NW-WO3 nanocrystals (ca. <100 nm width, 3-5 μm length) with anisotropic growth of monoclinic WO3 crystals to (002) and (200) planes and a polycrystalline character with randomly oriented crystallites in the lateral face of nanowires. The precursor preparation at 45 °C followed by calcination at 550 °C produced HP-WO3 nanocrystals (ca. 500-1000 nm diameter) with preferentially exposed (002) and (020) facets on the top-flat and side-rectangle surfaces, respectively, of hexagonal prismatic WO3 nanocrystals with a single-crystalline character. The HP-WO3 electrode exhibited the superior photoelectrochemical (PEC) performance for visible-light-driven water oxidation to that for the NW-WO3 electrode; the incident photon-to-current conversion efficiency (IPCE) of 47% at 420 nm and 1.23 V vs RHE for HP-WO3 was 3.1-fold higher than 15% for the NW-WO3 electrode. PEC impedance data revealed that the bulk electron transport through the NW-WO3 layer with the unidirectional nanowire structure is more efficient than that through the HP-WO3 layer with the hexagonal prismatic structure. However, the water oxidation reaction at the surface for the HP-WO3 electrode is more efficient than the NW-WO3 electrode, contributing significantly to the superior PEC water oxidation performance observed for the HP-WO3 electrode. The efficient water oxidation reaction at the surface for the HP-WO3 electrode was explained by the high surface fraction of the active (002) facet with fewer grain boundaries and defects on the surface of HP-WO3 to suppress the electron-hole recombination at the surface.

Photothermal Conversion of W18O49 with a Tunable Oxidation State

Preparation of WO<sub>x</sub>-TiO<sub>2</sub> and the Photocatalytic Activity under Visible Irradiation

Reversible Chemical Tuning of Charge Carriers for Enhanced Photoelectrochemical Conversion and Probing of Living Cells

Raman Spectroscopic Study of Oxidation and Phase Transition in W18o49 Nanowires

Combustion Synthesis and Excellent Photocatalytic Degradation Properties of W18O49

In Situsolvothermal Reduction Engineering Enables Delicate Control over Surface-Rich Oxygen Vacancies on Bi2WO6for Highly Efficient Photocatalytic CO2reduction

Low-temperature Synthesis and Electrical Transport Properties of W18O49 Nanowires

Absorption and Electrochromic Modulation of Near-Infrared Light: Realized by Tungsten Suboxide.

Electronic state tuning over Mo-doped W18O49 ultrathin nanowires with enhanced molecular oxygen activation for desulfurization

Temperature-Controlled Transformation of WO3 Nanowires into Active Facets-Exposed Hexagonal Prisms toward Efficient Visible-Light-Driven Water Oxidation

Monoclinic Tungsten Oxide With {100} Facet Orientation And Tuned Electronic Band Structure For Enhanced Photocatalytic Oxidations

Ce-Doped W18O49 Nanowires for Tuning N-2 Activation toward Direct Nitrate Photosynthesis

Phase‐Transition Induced Conversion into a Photothermal Material: Quasi‐Metallic WO2.9 Nanorods for Solar Water Evaporation and Anticancer Photothermal Therapy

Synthesis of plasmonic W18O49 interconnected nanowire frameworks with strong photo-enhanced hydrogen evolution reaction activity

Raman Study of Thermochromic Phase Transition in Tungsten Trioxide Nanowires

Modulating WO3 Crystal Orientation to Suppress Hydroxyl Radicals for Sustainable Solar Water Oxidation

Controlling Oxygen Vacancies of WOx Suboxides by ZnWO4 Nanophase Hybridization

Boosting near-infrared absorption properties enabled by oxygen vacancy engineering within tungsten trioxide

Solvent-dependent Structures and Photoluminescence of WO3-x, Nanomaterials Grown in Nonaqueous Solutions

Tuned Structures and Enhanced Photoluminescence of WO3- Nanomaterials by TiO2

A Dissolution‐Regeneration Route to Synthesize Blue Tungsten Oxide Flowers and their Applications in Photocatalysis and Gas Sensing