Utilization of the 3D-Printed Spine Model for Freehand Pedicle Screw Placement in Complex Spinal Deformity Correction.

Lee A Tan,Ketan Yerneni,Alexander Tuchman,Xudong J Li,Meghan Cerpa,Ronald A Lehman,Lawrence G Lenke
DOI: https://doi.org/10.21037/jss.2018.05.16
2018-01-01
Abstract:BACKGROUND:We aim to demonstrate the safety and efficacy of utilizing 3D-printed spine models to facilitate freehand pedicle screw placement in complex spinal deformity correction. Currently there is no data on using 3D-printed models for freehand pedicle screw placement spinal deformity correction. METHODS:All patients undergoing spinal deformity correction over a 16-month period (September 2015 - December 2016) at the Spine Hospital of Columbia University Medical Center by the senior surgeon were reviewed. 3D-printed spine models were used to facilitate intraoperative freehand pedicle screw placement in patients with severe spinal deformities. Intraoperative O-arm imaging was obtained after pedicle screw placement in all patients. Screws were graded as intrapedicular, <2 mm breach, 2-4 mm breach, and >4 mm breach; anterior breaches >4 mm were also recorded. Screw accuracy was compared to a historical cohort (not using 3D-printed models) using SPSS 23.0 (Chicago, IL, USA). RESULTS:A total of 513 freehand pedicle screws were placed from T1 to S1 in 23 patients. Overall, 494 screws (96.3%) were placed in acceptable positions according to the pre-operative plan, which had no statistically significant difference (P=0.99) compared to a historical cohort with less severe deformities. There were 84.2% screw that were intrapedicular or <2 mm breach; among the 81 screws (15.8%) with >2 mm breach, 67 were lateral breaches (most are intended juxtapedicular placement), whereas 14 were medial breaches. There were 11 screws (2.1%) that required repositioning due to pedicle violation, and eight screws (1.6%) had >4 mm anterior breach and required shortening. There was no neuromonitoring change or any other complications directly or indirectly related to freehand pedicle screw placement. CONCLUSIONS:The 3D-printed spinal model can make freehand pedicle screw placement safer in severe spinal deformity cases with acceptable accuracy, and no neurological or vascular complications.
What problem does this paper attempt to address?