Abstract:Normal planar laser induced fluorescence (N-PLIF) method has been widely applied in liquid film imaging and thickness measurements in circular tubes with large curvatures, but meets great challenges in liquid film thickness measurements in circular tubes with small curvatures or at plates. An alternative method is to place both the incident laser sheet and the camera below the bottom interface of a plate, forming the acute PLIF (A-PLIF) method with an acute laser optical path and camera alignment. However, the liquid film thickness measurements based on direct imaging with the A-PLIF method are still challenged by the decrease of image contrast and indistinct interfaces. This work further explores the A-PLIF method with a novel image processing approach through both static liquid film and moving liquid film measurements. In static liquid film measurements, brightness curves along the liquid film thickness direction are extracted to compare with numerical simulation results based on ray-tracing approach, in which the laser intensity attenuation, laser sheet thickness, fluorescence spectrum and top interface reflection are considered. The comparison indicates that out-of-focus imaging is the dominant factor for the expanding of measured brightness curves. Three distinct regions, i.e. the increasing region, slowly decreasing region and rapidly decreasing region, are identified on the brightness curves and the main fluorescence source of each region is analyzed theoretically. It is concluded that the total width of the two decreasing regions shows strong correlation to the liquid film thickness, which facilitates the evaluation of liquid film thickness through peak position determination of the brightness curve and linear fitting of the rapidly decreasing region. This method is further tested in the moving liquid film thickness measurement in a cross-flow tunnel at various cross-sections, which shows that it can be applied to the liquid film imaging and thickness measurements on small curvature or flat surfaces. (C) 2020 Elsevier Ltd. All rights reserved.

Simultaneous Measurement of Dynamic Force and Spatial Thin Film Thickness Between Deformable and Solid Surfaces by Integrated Thin Liquid Film Force Apparatus

The Surface Force Balance: Direct Measurement of Interactions in Fluids and Soft Matter

A Multi-Modal Miniature Surface Forces Apparatus (uSFA) for Interfacial Science Measurements

In Situ and Real-Time Tensile Testing of Thin Films Using Double-Field-of-view Electronic Speckle Pattern Interferometry

Automated optical liquid film thickness measurement method

Direct Measurement of Plowing Friction and Wear of a Polymer Thin Film Using the Atomic Force Microscope

Novel in situ sensing surface forces apparatus for measuring gold versus gold, hydrophobic, and biophysical interactions

Novel technique for mechanical characterization of thin polymeric tissue membrane

Pixel-dependent laser-induced fluorescence method for determining thin liquid film thickness distribution

Measurement and Quantification of Effective Slip Length at Solid–Liquid Interface of Roughness-Induced Surfaces with Oleophobicity

SMART Transfer Method to Directly Compare the Mechanical Response of Water-Supported and Free-Standing Ultrathin Polymeric Films.

Elastic deformation during dynamic force measurements in viscous fluids

New SFA techniques for studying surface forces and thin film patterns induced by electric fields.

Direct force measurement of microscopic droplets pulled along soft surfaces

Surface Force Apparatus and Thin Film Rheology for Additive-Treated Lubricant

Transient Surface Patterns During Adhesion and Coalescence of Thin Liquid Films.

Liquid film thickness measurements on a plate based on brightness curve analysis with acute PLIF method

High-Precision Large Deflection Measurements of Thin Films Using Time Sequence Speckle Pattern Interferometry

FM-AFM with hanging fiber probe for the study of liquid / liquid interfaces

Measuring Thin Films Using Quantitative Frustrated Total Internal Reflection (FTIR)

Microfluidic Approach for Rapid Interfacial Tension Measurement