Enhanced Photocurrent Density by Spin-Coated NiO Photocathodes for N-Annulated Perylene-Based P-Type Dye-Sensitized Solar Cells

Xing Li,Fengtao Yu,Sebastian Stappert,Chen Li,Ying Zhou,Ying Yu,Xin Li,Hans Agren,Jianli Hua,He Tian
DOI: https://doi.org/10.1021/acsami.6b04007
IF: 9.5
2016-01-01
ACS Applied Materials & Interfaces
Abstract:The low photocurrent density of p-type dye-sensitized solar cells (p-DSSCs) has limited the development of high-efficiency tandem cells due to the inadequate light-harvesting ability of sensitizers and the low hole mobility of semiconductors. Hereby, two new "push-pull" type organic dyes (PQ-1 and PQ-2) containing N-annulated perylene as electron donor have been synthesized, where the PQ-2-based p-DSSCs show higher photoelectric conversion efficiency (PCE) of 0.316% owing to the higher molar extinction compared to of that PQ-1. Additionally, the photocurrent densities were remarkably increased from 2.20 to 5.85 mA cm(-2) for PQ-1 and 2.45 to 6.69 mA cm(-2) for PQ-2 by spin-coated NiO photocathode based-p-DSSCs, respectively. This results are ascribed to the enhancement of hole transport rate, dye-loading amounts and transparency of NiO films in comparison to that prepared by screen-printing method. Electrochemical impedance spectroscopy and theoretical calculations studies indicate that the molecular dipole moment approaching closer to the NiO surface shifts the quasi-Fermi level to more positive levels, improving open-circuit voltage (Voc). Intensity-modulated photocurrent spectroscopy illustrates that the hole transit time in NiO films prepared in spin-coating is shorter than that prepared by screen-printing method.
What problem does this paper attempt to address?