Abstract:Demand for lithium-ion batteries (LIBs) has increased dramatically over the years due to the rapid market expansion of electric vehicles. However, many of the essential components of cathode materials, such as cobalt, nickel, manganese and lithium, are resource-limited and expensive[1]. Therefore, recycling of used LIB cathode materials is very important to conserve resources and the environment. Currently, the lithium secondary battery recycling technology mainly uses wet and dry smelting, but there is a disadvantage of high energy consumption due to the use of strong acid and the smelting process[2-3]. In this study, the cathode active material was separated from a pouch-type lithium secondary battery separated from a portable tablet that was over 10 years old and the chemical, structural, and electrochemical characteristics thereof were investigated. The cathode active materials were dismantled from a pouch-type LIB, which was removed from the tablet produced in 2011. The pouch cell was in a swelling state and the OCV was 0V due to internal short is expected. As a result of TGA analysis, the electrode composition was confirmed to be 92wt% of the cathode active material, 3wt% of the conductive agent, and 3wt% of the binder, respectively. The recovery rate of the active material is the best when a mixed solvent including NMP, heating, and ultrasonic, respectively. Through SEM and EDS analysis, copper metal due to dissolution of the negative electrode current collector was found on the surface of the positive electrode. As shown in Fig. 1, It can be seen that the positive electrode active material recovered using the composite solvent is a positive electrode active material that is a mixture of NCM active material and LMO active material. The XRD results shows a well layered structure and a Co 3 O 4 phase due to lithium deficiency. In order to examine the electrochemical characteristics of the recovered electrode, it was reassembled into a 2032 coin type cell and evaluated, and the discharge capacity of approximately 150mAh/g was recovered as shown in Fig. 2. The positive active material recovered according to the experimental results is estimated to be in a state of insufficient lithium, and a lithium compensation process is planned to be additionally performed in the future.

Reutilization of the Expired Tetracycline for Lithium Ion Battery Anode.

Direct and Indirect Recycling Strategies of Expired Oxytetracycline for the Anode Material in Lithium Ion Batteries

Exploiting the Non-Medical Value of Waste Expired Aminophylline for Lithium Ion Battery Anode

Feasibility of Expired Waste Aspirin for Use As Lithium-Ion Battery Anode

Recovery of Expired Lithium Carbonate Tablets for LiFePO 4 /C Cathode

Direct Utilization of Expired Waste Acetaminophen as Organic Anode in Lithium‐Ion Batteries

Reductive transformation and synergistic action mechanism in the process of treating spent lithium-ion batteries with antibiotic bacteria residues

The Synchronous Reutilization of the Expired Ferrous Sulfate Granules and Waste Li Foils for LiFePO4/C Cathode

Recycled Tetrahedron-Like CuCl from Waste Cu Scraps for Lithium Ion Battery Anode.

Reaction mechanism of antibiotic bacteria residues as a green reductant for highly efficient recycling of spent lithium-ion batteries

N-doped Carbon Microspheres Anode from Expired Vitamin B1 Injections for Lithium Ion Battery

Research for Electrochemical & Structural Properties of Recycling Cathode Materials for End of Life Lib

An Emerging and Consummate Photocatalysis-Assisted Strategy for Efficient Recycling of Spent Lithium-Ion Batteries

Sustainable Recycling of Cathode Scrap towards High‐Performance Anode Materials for Li‐Ion Batteries

Electrochemical Restoration of Battery Materials Guided by Synchrotron Radiation Technology for Sustainable Lithium-Ion Batteries

The Foreseeable Future of Spent Lithium-Ion Batteries: Advanced Upcycling for Toxic Electrolyte, Cathode, and Anode from Environmental and Technological Perspectives

Electrochemical Methods for the Removal of Impurities from the Graphite Anode in Spent Ternary Lithium-Ion Batteries

Production of the C/TiO2 composite with a high-performance electrochemical property from titanium-rich sludge via in-situ C coating

A Closed-Loop Process for Recycling LiNixCoyMn(1−x−y)O2 from Mixed Cathode Materials of Lithium-Ion Batteries

Rapid Degrading Carbamazepine in a Novel Advanced Oxidation Process of Bisulfite Activated by Lithium Cobaltate Recovered from Spent Lithium-ion Battery

Experimental Study on Recycling of Spent Lithium-Ion Battery Cathode Materials