Energy-Dispersive Small-Angle X-Ray Scattering With Cone Collimation Using X-Ray Capillary Optics

Fangzuo Li,Zhiguo Liu,Tianxi Sun
DOI: https://doi.org/10.1063/1.4962709
IF: 1.6
2016-01-01
Review of Scientific Instruments
Abstract:Energy-dispersive small-angle X-ray scattering (ED-SAXS) with an innovative design of cone collimation based on an ellipsoidal single-bounce capillary (ESBC) and a polycapillary parallel X-ray lens (PPXRL) had been explored. Using this new cone collimation system, scattering angle 2 theta has a theoretical minimum angle related to the mean half-opening angle of the hollow cone beam of 1.42 mrad, and with the usable X-ray energy ranging from 4 to 30 keV, the resulting observable scattering vector q is down to a minimum value of about 0.003 angstrom(-1) (or a Bragg spacing of about 2100 angstrom). However, the absorption of lower energies by X-ray capillary optics, sample transmission, and detector response function limits the application range to lower energy. Cone collimation ED-SAXS experiments carried out on pure water, Lupolen, and in situ temperature-dependent measurement of diacetylenic acid/melamine micelle solid were presented at three different scattering angles 2 theta of 0.18 degrees, 0.70 degrees and 1.18 degrees to illustrate the new opportunities offered by this technique as well as its limitations. Also, a comparison has been made by replacing the PPXRL with a pinhole, and the result shows that cone collimation ED-SAXS based on ESBC with PPXRL was helpful in improving the signal-to-noise ratio (i.e., reducing the parasitic background scattering) than ESBC with a pinhole. The cone collimation instrument based on X-ray capillary optics could be considered as a promising tool to perform SAXS experiments, especially cone collimation ED-SAXS has potential application for the in situ temperature-dependent studying on the kinetics of phase transitions. Published by AIP Publishing.
What problem does this paper attempt to address?