Remote Detection of HCN, HF, and Nerve Agent Vapors Based on Self-Referencing, Dye-Impregnated Porous Silicon Photonic Crystals
Yi-Sheng Lu,Sanahan Vijayakumar,Arnaud Chaix,Brian R. Pimentel,Kyle C. Bentz,Sheng Li,Adriano Chan,Charlotte Wahl,James S. Ha,Deborah E. Hunka,Gerry R. Boss,Seth M. Cohen,Michael J. Sailor
DOI: https://doi.org/10.1021/acssensors.0c01931
IF: 8.9
2020-12-02
ACS Sensors
Abstract:A one-dimensional photonic crystal is prepared from porous silicon (pSi) and impregnated with a chemically specific colorimetric indicator dye to provide a self-referenced vapor sensor for the selective detection of hydrogen fluoride (HF), hydrogen cyanide (HCN), and the chemical nerve agent diisopropyl fluorophosphate (DFP). The photonic crystal is prepared with two stop bands: one that coincides with the optical absorbance of the relevant activated indicator dye and the other in a spectrally "clear" region, to provide a reference. The inner pore walls of the pSi sample are then modified with octadecylsilane to provide a hydrophobic interior, and the indicator dye of interest is then loaded into the mesoporous matrix. Remote analyte detection is achieved by measurement of the intensity ratio of the two stop bands in the white light reflectance spectrum, which provides a means to reliably detect colorimetric changes in the indicator dye. Indicator dyes were chosen for their specificity for the relevant agents: rhodamine-imidazole (RDI) for HF and DFP, and monocyanocobinamide (MCbi) for HCN. The ratiometric readout allows detection of HF and HCN at concentrations (14 and 5 ppm, respectively) that are below their respective IDLH (immediately dangerous to life and health) concentrations (30 ppm for HF; 50 ppm for HCN); detection of DFP at a concentration of 114 ppb is also demonstrated. The approach is insensitive to potential interferents such as ammonia, hydrogen chloride, octane, and the 43-component mixture of VOCs known as EPA TO-14A, and to variations in relative humidity (20–80% RH). Detection of HF and HCN spiked into the complex mixture EPA TO-14A is demonstrated. The approach provides a general means to construct robust remote detection systems for chemical agents.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acssensors.0c01931?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acssensors.0c01931</a>.UV–vis absorbance spectra and calibration curves for RDI and MCbi indicator dyes as a function of analyte concentration; Water contact angle images, FTIR spectra of pSi photonic crystal sensors; <sup>1</sup>H NMR and Mass spectra of RDI and Cbi dyes; Images of cobinamide solutions at various stages of titration with HCN; ATR-FTIR spectra of RDI and Cbi dry powder samples; schematics of vapor dosing setup for HF-sensing experiment; schematic mechanism of RDI reaction with HF and temporal response curves for RDI–pSi-Si(C<sub>18</sub>) photonic crystal sensors exposed to HF<sub>(g)</sub>; temporal response curve of RDI–pSi-Si(C<sub>18</sub>) photonic crystal sensor exposed to DFP vapor; schematics of vapor dosing setup for HCN<sup>–</sup> sensing experiment; experimental setup for remote sensing of HF vapor (<a class="ext-link" href="/doi/suppl/10.1021/acssensors.0c01931/suppl_file/se0c01931_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.
chemistry, multidisciplinary, analytical,nanoscience & nanotechnology