Abstract:The liquid-phase exfoliation (LPE) of black phosphorus (BP) is a strategic route for the large-scale production of phosphorene and few-layer BP (FL-BP) flakes. The exploitation of this exfoliated material in cutting-edge technologies, e.g., in flexible electronics and energy storage, is however limited by the fact that the LPE of BP is usually carried out at a high boiling point and in toxic solvents. In fact, the solvent residual is detrimental to device performance in real applications; thus, complete solvent removal is critical. Here, we tackle these issues by exfoliating BP in different low boiling-point solvents. Among these solvents, we find that acetone also provides a high concentration of exfoliated BP, leading to the production of FL-BP flakes with an average lateral size and thickness of c.a. 30 and 7 nm, respectively. The use of acetone to produce less defective few-layer BP flakes (FL-BPacetone) from bulk crystals is a straightforward process which enables the rapid preparation of homogeneous thin films thanks to the fast solvent evaporation. The ratio of edge to bulk atoms for the BP flakes here produced, combined with the use of low-boiling-point solvents for the exfoliation process suggests that these thin films are promising anodes for lithium-ion batteries. To this end, we tested Li-ion half cells with FL-BPacetone anodes achieving a reversible specific capacity of 480 mAh/g at a current density of 100 mA/g, over 100 charge/discharge cycles. Moreover, a reversible specific capacity of 345 mAh/g is achieved for the FL-BPacetone-based anode at a high current density (i.e., 1 A/g). These findings indicate that the FL-BPacetone-based battery is promising with regards to the design of fast charge/discharge devices. Overall, the presented process is a step forward toward the fabrication of phosphorene-based devices.

Preparation Of Large Size, Few-Layer Black Phosphorus Nanosheets Via Phytic Acid-Assisted Liquid Exfoliation

Production of High-Quality and Large Lateral-Size Black Phosphorus Nanoparticles/nanosheets by Liquid-Phase Exfoliation

Large-Scale, Highly Efficient, and Green Liquid-Exfoliation of Black Phosphorus in Ionic Liquids.

Liquid Exfoliation of Solvent-Stabilized Few-Layer Black Phosphorus for Applications Beyond Electronics.

Scalable Clean Exfoliation of High‐Quality Few‐Layer Black Phosphorus for a Flexible Lithium Ion Battery

Liquid-phase exfoliation of black phosphorus and its applications

An Ultrahigh Pressure Homogenization Technique for Easily Exfoliating Few-Layer Phosphorene from Bulk Black Phosphorus

Electrochemically Exfoliated Functionalized Black Phosphorene and Its Polyurethane Acrylate Nanocomposites: Synthesis and Applications

A Novel Strategy for Liquid Exfoliation of Ultrathin Black Phosphorus Nanosheets

Nanostructure and functional group engineering of black phosphorus via plasma treatment for CO2 photoreduction

Ultrafast Electrochemical Expansion of Black Phosphorus Toward High-Yield Synthesis of Few-Layer Phosphorene

Progress in the synthesis of 2D black phosphorus beyond exfoliation

Ultrafast Cathodic Exfoliation of Few-Layer Black Phosphorus in Aqueous Solution

Exfoliation of Few-Layer Black Phosphorus in Low-Boiling-Point Solvents and Its Application in Li-Ion Batteries

Synthesis of thin-film black phosphorus on a flexible substrate

Interface-mediated nano-downsizing for concentrated black phosphorene dispersions in volatile systems

Electrochemical exfoliation of two-dimensional layered black phosphorus and applications

Solvent Exfoliation of Electronic-Grade, Two-Dimensional Black Phosphorus

Liquid exfoliation of solvent-stabilised black phosphorus: applications beyond electronics

Conjugated Polymer Coating Enabled Light-Resistant Black Phosphorus with Enhanced Stability

Liquid‐Based Exfoliation of Black Phosphorus into Phosphorene and Its Application for Energy Storage Devices