Abstract:This paper presents a novel, digitally configurable, switching oscillator-based impulse radio ultra-wideband (IR-UWB) transmitter that is robust to process variations. The pulse width and pulse position properties of the output waveform are configurable to ensure operation for the desired bandwidth and output pulse energy values. The architecture is based on a cross-coupled LC voltage-controlled oscillator (LC VCO) implemented with a custom-designed on-chip balun at a center frequency of 2.4 GHz. With the usage of this on-chip balun, the need for an extra buffer stage is eliminated, and the highest possible efficiency is achieved with the proper turns ratio selected. The generated digital control pulse signals are also used to ensure fast start-up and UWB operation while maintaining low power consumption with an implemented on/off tail switching scheme. The presented IR-UWB transmitter that occupies a total area of 0.35 mm 2 is fabricated in the United Microelectronics Corporation (UMC) 180-nm mixed-mode/radio frequency (RF) CMOS process. The measured output voltage swing of the fabricated transmitter is 0.812 V on a 50- Ω load for the 200 Mb/s data rate, and the bandwidth is measured as 902 MHz. The achieved frequency tuning range is 1 GHz and the fabricated transmitter can drive 50 Ω , 75 Ω and 100 Ω loads with measured efficiency values 4.16%, 5.76%, and 4.05%, respectively. Compared to other works in the literature, this design achieves a higher output pulse energy at a higher data rate while maintaining low power consumption and, thus, high efficiency.

The Design of an Energy-Efficient IR-UWB Transmitter with Wide-Output Swing and Sub-Microwatt Leakage Current

A CMOS Ultra Low-Power and Highly Efficient UWB-IR Transmitter for WPAN Applications

A Power-Efficient All-Digital Ir-Uwb Transmitter with Configurable Pulse Shaping by Utilizing A Digital Amplitude Modulation Technique

A power scalable and high pulse swing UWB transmitter for wirelessly-powered RFID applications

An Ultra Low-Power Dual-Band IR-UWB Transmitter in 130-nm CMOS

A 0.18&#x003bc;m CMOS UWB Transmitter with Reconfigurable Pulse Width

An Ultra Low Power and High Efficiency Uwb Transmitter for Wpan Applications

A Low-Complexity FM-UWB Transmitter with Digital Reuse and Analog Stacking

High data rate and energy efficient configurable IR-UWB transmitter with an integrated balun

A 21.3%-Efficiency Clipped-Sinusoid UWB Impulse Radio Transmitter with Simultaneous Inductive Powering and Data Receiving

A Dual-Carrier IR-based UWB Transmitter with Improved Spectral Efficiency

0.15-Nj/b 3–5-Ghz IR-UWB System with Spectrum Tunable Transmitter and Merged-Correlator Noncoherent Receiver

A Current-Mode 6&#x2013;9ghz UWB Transmitter with Output Power Flattening Technique

Design and analysis of a current-reuse transmitter for ultra-low power applications

Design Considerations for Low-power IR-UWB Receiver and LNA

Low Power Amplitude and Spectrum Tunable IR-UWB Transmitter

Ultrawideband Power-Switchable Transmitter with 17.7-Dbm Output Power for See-Through-Wall Radar.

20-pJ/Pulse 250 Mbps Low-Complexity CMOS UWB Transmitter for 3–5 GHz Applications

A 3-5ghz Amplitude And Spectrum Tunable Impulse Radio Uwb Transmitter

A 3.1&Amp;#x2013;4.8-Ghz Delay-Line-based Frequency-Hopping IR-UWB Transmitter in 65-NM CMOS Technology

A 1.14mW 750kb/s FM-UWB transmitter with 8-FSK subcarrier modulation