Abstract:<p>Billions of wireless sensing devices must be powered for IoT applications. Collecting energy from the ambient environment to power sensor nodes is a promising solution. Solar energy has been one of the main sources of ambient energy due to its availability, higher power density, and the maturity of the solar photovoltaic industry. However, there are many scenarios (indoor environment, outdoor environment during nighttime, poor weather conditions, underground, etc) where ambient solar energy is either not available or not sufficient for practical applications. For such scenarios, other renewable sources of energy must be sought. Typically, not enough power is collected from one ambient source to charge sensor nodes for continuous operation. In this work, we present a multi‐source energy harvester that collects RF and thermal energy (both available 24 hours) from the ambient environment simultaneously. The RF energy harvester is multi‐band and collects power from GSM (900, 1800 MHz) and 3G (2100 MHz). The thermal harvester converts diurnal temperature fluctuations to electrical energy using high thermal effusivity phase change material. Extensive field testing has been performed in three different conditions—outdoors, indoors, and buried underground—to highlight the usefulness of the multi‐source energy harvester in all these environments. When one source is disabled, the harvester still generates energy from the remaining active source and can enable continuous operation of futuristic IoT sensors. As a proof of concept, a real‐world IoT application is demonstrated, where temperature and humidity sensors are powered by the multi‐source energy harvester. Continuous robust operation of the sensors and wireless data transmission after each 3.7 seconds are expected when both harvesters operate in full mode. Scenarios, where only single thermal energy harvester or only single RF energy harvester operates, are also demonstrated and data transmission with average time intervals of 30 seconds and 9 minutes is achieved, respectively.</p>

Using Human Body As a Monopole Antenna for Energy Harvesting from Ambient Electromagnetic Energy

Evaluation of Propagation Characteristics Using the Human Body as an Antenna

A multi-frequency and multi-mode metasurface energy harvester for RF energy harvesting

Investigation of SAR Reduction Using Flexible Antenna with Metamaterial Structure in Wireless Body Area Network

Radio Frequency Energy Harvesting Technology

Design of Flexible Dual‐band Antenna and Metamaterial Structure for Wearable Body Area Network

A hybrid piezoelectric-electromagnetic body energy harvester: Design and experiment validation

Energy Harvesting Using a Low-Cost Rectenna for Internet of Things (IoT) Applications

WiFi Energy-Harvesting Antenna Inspired by the Resonant Magnetic Dipole Metamaterial

Dual-band RF energy harvesting for low-power IoT devices

A wireless sensing platform utilizing ambient RF energy

The State-of-the-Art and the Future Trends of Electromagnetic Energy Harvesting

Multi‐source ambient energy harvester based on RF and thermal energy: Design, testing, and IoT application

Filtering Antennas For Energy Harvesting In Wearable Systems

Rf Energy Harvesting with Broadband Antenna

RF Energy Harvesting System Based on an Archimedean Spiral Antenna for Low-Power Sensor Applications

A wide-angle incidence, broadband rectified metasurface for radar frequency band EM energy harvesting and wireless power transfer

Ultra-high-frequency Radio Frequency Identification Tag Antenna Applied for Human Body and Water Surfaces

A Switch Type RF Energy Harvesting and Management System

Development of 2400-2450 MHz Frequency Band RF Energy Harvesting System for Low-Power Device Operation

Wi-Fi RF Energy Harvesting for Battery-Free Wearable Radio Platforms