Abstract:In order to study the numerical variation law of the internal ballistic overload of the guided projectile under different coated mixed charge structures, and to provide a basis for the development of a new type of high muzzle velocity and low overload propellant charge design, taking a large-caliber suppressed artillery as the simulation object, the layered combustion model of the coated propellant was established by using the one-dimensional two-phase flow theory, and the lace 37-hole nitroguanidine propellant was used as the main charge (MC) and lace 19-hole nitroguanidine coated propellant as auxiliary charge (B). The effects of mixed charges with different charge mass, different mixing ratios and different coating layer thicknesses on the internal ballistic overload value were studied by simulation calculation. The research results show that the increase of the total charge mass will increase the overload impact of the guided projectile and the muzzle velocity of the projectile ; with the increase of the thickness of the coating layer and the proportion of the coated propellant in the mixed charge ratios, the longitudinal overload and the muzzle velocity of the projectile in the chamber of the guided projectile will be decreased to a certain extent and the time point when the maximum overload occurs will be delayed; under the structure of the coated mixed charge, the influence of the proportion of coated propellant in different mixed charge ratios and the coating layer thickness of coated propellant on the launch overload of the guided projectile is greater than the muzzle velocity of the projectile, and the effect of reducing the firing overload in the chamber by increasing the proportion of coated propellant in different mixed charge ratios is the most significant.

Condensed phase particle acceleration analysis for overload test ground of solid rocket motor

Strain-rate-dependent Cohesive Zone Modelling of Charge Damage Behavior when a Projectile Penetrates Multilayered Targets

Research on the Safety of Long Term Storage Solid Rocket Motor with Debonded Layer

Simulation of dynamical loads for large controllable pitch propellers ground tests

INVESTIGATION OF ATOMIZATION PERFORMANCE ON A CENTRIFUGAL FUEL SLINGER WITH A PHASE DOPPLER ANEMOMETER

Experimental Research on Electron Density in Solid-Rocket Motor Plume

Method of Determining the Critical Impact Velocity of Energetic Devices

Experimental and numerical study on slag deposition in solid rocket motor

Simulation and Application of a New Multiphase Flow Ablation Test System for Thermal Protection Materials Based on Liquid Rocket Engine

Experimental and numerical investigation on thermochemical erosion and mechanical erosion of carbon-based nozzles in hybrid rocket motors

Numerical analysis for two-phase flow in dual-thrust chamber with finocyl grain

Numerical Simulation on Cold-Flow Impact of the Soft Pulse Separation Device in Dual Pulse Solid Rocket Motor

Numerical Investigation on the Mechanism of Solid Rocket Motor Instability Induced by Differences between On-Ground and In-Flight Conditions

Aerodynamic and aeroacoustic characteristics of rocket sled under strong ground effect

Structural Integrity Assessment of a Solid Propellant Grain Considering Confining Pressure Effect

Experimental study on the collision behaviors of micron-sized aluminum droplets with solid wall in high temperature burned gas

Numerical Simulation Coupling on Fluid Flow and Heat Transfer in Nozzle and Equipment Cabin of Solid Rocket Motor during Operation Process

Numerical simulation research of inner ballistic overload of guided projectile based on coated mixed charge

Influences of thermal physical property parameters on operating characteristics of simulated rotating detonation ramjet fueled by C12H23

Low speed impact simulation of explosive charge based on three-dimensional numerical manifold method

Numerical simulation of the effect of multiple factors on the ignition process of a solid rocket motor