Abstract:Nano-sized aluminum (Nano-Al) powders hold promise in enhancing the total energy of explosives and the metal acceleration ability at the same time. However, the near-detonation zone effects of reaction between Nano-Al with detonation products remain unclear. In this study, the overall reaction process of 170 nm Al with RDX explosive and its effect on detonation characteristics, detonation reaction zone, and the metal acceleration ability were comprehensively investigated through a variety of experiments such as the detonation velocity test, detonation pressure test, explosive/window interface velocity test and confined plate push test using high-resolution laser interferometry. Lithium fluoride (LiF), which has an inert behavior during the explosion, was used as a control to compare the contribution of the reaction of aluminum. A thermochemical approach that took into account the reactivity of aluminum and ensuing detonation products was adopted to calculate the additional energy release by afterburn. Combining the numerical simulations based on the calculated afterburn energy and experimental results, the parameters in the detonation equation of state describing the Nano-Al reaction characteristics were calibrated. This study found that when the 170 nm Al content is from 0% to 15%, every 5% increase of aluminum resulted in about a 1.3% decrease in detonation velocity. Manganin pressure gauge measurement showed no significant enhancement in detonation pressure. The detonation reaction time and reaction zone length of RDX/Al/wax/80/15/5 explosive is 64 ns and 0.47 mm, which is respectively 14% and 8% higher than that of RDX/wax/95/5 explosive (57 ns and 0.39 mm). Explosive/window interface velocity curves show that 170 nm Al mainly reacted with the RDX detonation products after the detonation front. For the recording time of about 10 μs throughout the plate push test duration, the maximum plate velocity and plate acceleration time accelerated by RDX/Al/wax/80/15/5 explosive is 12% and 2.9 μs higher than that of RDX/LiF/wax/80/15/5, respectively, indicating that the aluminum reaction energy significantly increased the metal acceleration time and ability of the explosive. Numerical simulations with JWLM explosive equation of state show that when the detonation products expanded to 2 times the initial volume, over 80% of the aluminum had reacted, implying very high reactivity. These results are significant in attaining a clear understanding of the reaction mechanism of Nano-Al in the development of aluminized explosives.

Research on Equation of State for Detonation Products of Aluminized Explosive

An Equation of State for the Detonation Product of Copper Oxide/aluminum Nanothermite Composites

Research of detonation products of RDX/Al from the perspective of composition

Numerical Investigation on Effects of Ignition Energy on Two-phase Detonation Wave Formation

Evaluation of the Detonation Characteristics of Aluminized DNAN‐Based Melt‐Cast Explosive by the Detonation Cylinder Test

Cylinder Test of Aluminized Explosives and Its Numerical Simulation

A Continuum Constitutive Model and Computational Method of Explosive Detonation

Detonation Characteristics of an Aluminized DNAN‐Based Melt‐Cast Explosive

The Role of Al Reaction Rate in the Damage Effect and Energy Output of RDX‐Based Aluminized Explosives in Concrete

On weak influence of aluminum powder size on its post-detonation reaction in different time scales

Numerical simulation on the bomb case effects of non‐ideal aluminized explosive

Comparative study on the equation of state of detonation products

Exploring the Combustion Mechanism of Single Micron-Sized Aluminum Particles with a Numerical Model

Numerical Investigation on New Engine Combustion Charactristic of Helicopter

Equation of State of Detonation Products for PETN Explosive

Prediction of the Chapman-Jouguet Chemical Equilibrium State in a Detonation Wave from First Principles Based Reactive Molecular Dynamics.

Experimental Evaluation of Aluminum Powder Fuel in a Hydrogen/oxygen Detonation Tube

Calculating detonation performance of explosives by VLWR thermodynamics code introduced with universal VINET equation of state

Effects of nano-sized aluminum on detonation characteristics and metal acceleration for RDX-based aluminized explosive

Reactive Molecular Dynamics Simulation of Thermal Decomposition for Nano-Aluminized Explosives

An Approach to Incorporate the Detonation Shock Dynamics into the Calculation of Explosive Acceleration of Metals