Abstract:Summary form only given. The dielectric barrier discharge (DBD) in air at atmospheric pressure was investigated with electrical measurement and fast photography. Homogeneous DBD without filaments was obtained in a gap of a length as long as 3 mm, which has never been reported in previous literatures. The air gap was in between two plane-parallel electrodes of 50 mm in diameter, each covered by a specific ceramic plate with a thickness of 1.5∼3.25 mm. By subtracting the displacement current from the total current, there appears one current peak per half cycle of the applied sinusoidal voltage, which is typical for homogeneous DBD. The current peak is 1 mA in amplitude and about 85 µs in FWHM (full width at half magnitude). Side-view photographs with 10 ns exposure time taken at the time about the peak of the current pulse showed that there were no filaments in the discharge gap. A luminous layer close to the instantaneous anode was observed, indicating the homogeneous DBD was a Townsend discharge. When choosing a ceramic thinner than 1.5 mm, some filaments randomly appeared in the gap, as was called a mixed mode of homogenous and filamentary DBD. This was because in DBD the dielectric capacitance played an important role in the limitation of the discharge current. A smaller capacitance would help to avoid an electron avalanche overdeveloping to a streamer. When a stable Townsend discharge was maintained, the breakdown voltage was determined to be only 8.3 kV, much lower than the static breakdown voltage of 11.2 kV for the same air gap of 3 mm in length. The formation of Townsend discharge was attributed to the uniqueness of the shallow traps on the surface of the specific ceramic plate and the common effect of the current limitation by dielectric.

Morphological Image Analysis of Surface Dielectric Barrier Discharge at Atmospheric Air

Experimental Research on Microdischarge Characteristics of DBD

Electrical Modeling of Dielectric Barrier Discharge Considering Surface Charge on the Plasma Modified Material

Dielectric Barrier Discharge and Its Applications

Optical and Electrical Characteristics of Air Dielectric Barrier Discharges in Mode Transition at Atmospheric Pressure

Study of Characteristics of Coplanar Dielectric Barrier Discharge

Experimental study of homogeneous dielectric barrier discharge in air at atmospheric pressure

Characteristics of Nanosecond-pulse Dielectric Barrier Discharge in Atmospheric Air

Nanosecond Repetitively Pulsed Dielectric Barrier Discharge in Air at Atmospheric Pressure

Simultaneous measurement of electrical potential on both sides of the dielectric surface in a parallel-plate dielectric barrier discharges and analysis of net electric field

Study of Homogeneous DBD with Fine Wire Meshes and PET Films in Air at Atmospheric Pressure

Preliminary Investigation of A Dielectric Barrier Discharge Lamp in Open Air at Atmospheric Pressure

Simulation Study on the Mechanism of Wire– Cylinder Air Dielectric Barrier Discharge Under Atmospheric Pressure

Characteristics of annular surface dielectric barrier discharge with microsecond pulse under water-covered condition

Electrical and optical characterization of multi-hollow surface dielectric barrier discharge in configuration with the air-exposed electrode

A Comparative Study of Water Electrodes Versus Metal Electrodes for Excitation of Nanosecond-Pulse Homogeneous Dielectric Barrier Discharge in Open Air

Partial Discharge Imaging Correlated with Phase-Resolved Patterns in Non-Uniform Electric Fields with Various Dielectric Barrier Materials

Effect of nitrogen/oxygen ratios on surface charge distributions generated by repetitive surface dielectric barrier discharges

Numerical simulation of air DBD under standard atmospheric pressure

Excitation of Atmospheric Pressure Uniform Dielectric Barrier Discharge Using Repetitive Unipolar Nanosecond-Pulse Generator

Uniform of Unipolar Nanosecond Pulse DBD in Atmospheric Air