Abstract:An experimental study is conducted on localized bulging of inflated latex rubber tubes of a range of wall thicknesses and tube lengths, guided by newly emerged analytical results. In the case when the tube has one free closed end that may or may not be subjected to a dead weight, the initiation pressure for localized bulging is determined by a bifurcation condition, and the propagation pressure is determined by Maxwell's equal-area rule. It is shown that after bulge initiation the pressure will decrease monotonically towards, but will never reach, the propagation pressure, and it is when the pressure is sufficiently close to this propagation pressure that rapid propagation of the bulge in the axial direction takes place. It is found that the experimentally observed initiation pressure is around 15% below the theoretical prediction, which is consistent with the fact that bulging initiation is a sub-critical phenomenon and is therefore sensitive to imperfections. The experimentally observed propagation pressure is always very close to the theoretical prediction, which confirms the insensitivity of this pressure to imperfections and demonstrates the predictive power of the material model fitted from our own experiments on equibiaxial stretching. In the other case when the tube is first stretched and then fixed at both ends, bulge initiation takes place in the same manner as in the previous case, but the propagation pressure is no longer determined by Maxwell's equal-area rule. After bulge initiation the pressure will first decrease to a minimum and then rises slowly, and it is on the latter ascending path that the bulge starts to propagate rapidly in the axial direction. A semi-analytical method is proposed for the determination of the minimum pressure. Numerical simulations with the use of the software Abaqus are also conducted to verify the theoretical predictions. (C) 2018 Elsevier Ltd. All rights reserved.

Electromagnetic tube bulging due to axial pressure produced with a rigid drive block

Numerical simulation and experimental study on axial compression electromagnetic bulging of aluminum alloy tube

Magneto-Thermo-Elastic Theoretical Solution for Functionally Graded Thick-Walled Tube under Magnetic, Thermal and Mechanical Loads Based on Voigt Method

An Experimental Study of Localized Bulging in Inflated Cylindrical Tubes Guided by Newly Emerged Analytical Results

Effect of pulse width of middle-coil current on deformation behavior in electromagnetic tube forming under two-stage coils system

Mechanical Performance of Multi-Cell Thin-Walled Tubes under Static and Dynamic Axial Loading

Analytical model for local bulging failure of mini-BRBs with circular restraint tubes

Magnetic and Electric Bulge-Test Instrument for the Determination of Coupling Mechanical Properties of Functional Free-Standing Films and Flexible Electronics

The influence of the MRE forming medium and axial feeding on the forming quality of thin-walled Inconel 718 bellow manufactured by a bulging process: finite element simulation and experimentation

Axial Active-Passive Suspension Electromagnetic System in Radial Air Gap for the Maglev Pump.

Behaviour of expansion tubes under impact load: Deformation mode and mechanical response

Study on the Efficiency of Simultaneous Tube Compression and Expansion Electromagnetic Forming

Plastically Deformed Tubes Subjected to Mechanical Expansion Processes

A Theoretical Study of the Expansion Metal Tubes

Study on Numerical Simulation and Test of Hydro-bulging Axle Housings

Axial Crushing of Triangular Tubes

Tube Collapse under Combined External Pressure, Tension and Bending

Experimental Study on Axial Compression of Circular Steel Tube Reinforced by Self-Tapping Cable and Sleeve Tube

Experimental, numerical, and theoretical studies of the response of short cylindrical stainless steel tubes under lateral air blast loading

Investigation on bearing resistance of thin-walled circular steel tube subjected to eccentric loading

Axially Movable Electromagnetic Forming System for Large-Scale Metallic Sheet