Abstract:In the ultra‐high frequency (UHF) technique, the partial discharge inside the power transformer can be localized by the hyperbolic equations. This method is sensitive to the time difference of arrival (TDOA) between the sensors because a small error in the TDOA vector may introduce a considerable localization error. This sensitivity depends on where the UHF sensors are installed on the transformer tank. By properly positioning the UHF sensors on the tank, this sensitivity is reduced. This paper presents a new method to find the best places on the transformer tank for installing the UHF sensors in such a way that the errors in the TDOA vector have the least effect on the localization accuracy. This paper proposes a new method for improving the partial discharge (PD) localization accuracy by detecting the best places of ultra‐high frequency (UHF) sensors on the power transformer tank. In this way, firstly, the critical sites inside the power transformer that can produce PD are determined. Then the sensors' positioning is done in such a way that if the PD happens at each point of these critical sites, the distance between the estimated PD location obtained by solving the time difference of arrival (TDOA) equations and the actual PD location is laid in an acceptable range. For this purpose, the TDOA equations are linearized around the critical PD coordinates as a matrix form A.X = B. The configuration of the sensor positions that minimizes the condition number of the matrix A is the best configuration. To evaluate the effectiveness of the proposed method, several simulations and evaluations are performed on a power transformer in the CST software. The obtained results and comparing them with the previous method and also conventional arbitrary sensors positioning confirm the effectiveness of this method.

A New UHF Sensor for Spatial Location of Partial Discharge Sources

Partial Discharge Wideband Full-Band High-Gain Resonant Cavity UHF Sensor Research

Location of PD by Searching in Space Using UHF Method

Research on Miniaturized UHF Sensing Technology for PD Detection in Power Equipment Based on Symmetric Cut Theory

Minimally invasive nephron‐sparing surgery for renal cell cancer

Partial Discharge Direction of Arrival Estimation in Air-insulated Substation by UHF Wireless Array and RSSI Maximum Likelihood Estimator

Passive Wireless Partial Discharge Sensors with Multiple Resonances

Design and Implementation of Ultra-Wide Band Antenna for Partial Discharge Detection in High Voltage Power Equipment

An Acoustic Localization Sensor Based on MEMS Microphone Array for Partial Discharge

Ultra‐high frequency sensors positioning on the power transformer to mitigate the negative effects on the partial discharge localization accuracy

Flexible Planar Monopole Built-in GIS PD Sensor Based on Meandering Technology

Use of ultrasonic array method for positioning multiple partial discharge sources in transformer oil

Study on the Ultra-High-frequency Sensors for PD Detection in Power Transformer

Fiber Optic MEMS Ultrasonic Sensor and its Application in Partial Discharge Detection

Mie theory calculations: new progress, with emphasis on particle sizing.

Study on Balun Miniaturized Flexible Archimedes Spiral Antenna for Partial Discharge Detection

Field test on a transformer for partial discharge location by uwb-rf method

Partial Discharge Detection Technology for Switchgear Based on Near-Field Detection

A Denoising Method for Partial Discharge Ultrasonic Signals in GIS Based on Ultra-High Frequency Signal Synchronization

Design of High-Sensitivity Flexible Low-Profile Spiral Antenna Sensor for GIS Built-in PD Detection

Partial discharge localisation in transformers using UHF technique: non-iterative method