Abstract:Today, online partial discharge (PD) measurements are common practice to assess the condition status of dielectrics in high-voltage (HV) electrical grids. However, when online PD measurements are carried out in electrical facilities, several disadvantages must be considered. Among the most important are high levels of changing electrical noise and interferences, signal phase couplings (cross-talk phenomena), and the simultaneous presence of various defects and difficulties in localizing and identifying them. In the last few decades, various PD-measuring systems have been developed to deal with these inconveniences and try to achieve the adequate supervision of electrical installations. In the state of the art, one of the main problems that electrical companies and technology developers face is the difficulty in characterizing the measuring system's functionalities in laboratory setups or in real-world facilities, where simulated or real defects must be detected. This is mainly due to the complexity and costs that the laboratory setups entail and the fact that the facilities are permanently in service. Furthermore, in the latter scenario, owners cannot assign facilities to carry out the tests, which could cause irreversible damage. Additionally, with the aforementioned installations, a comparison of results over time in various locations is not possible, and noise conditions cannot be controlled to perform the characterizations in a correct way. To deal with the problems indicated, in this article, an affordable scale modular test platform that simulates an HV installation is presented, where real on-site PD measuring conditions are simulated and controlled. In this first development, the HV installation comprises a cable system connected at both ends to a gas-insulated substation (GIS). As the most common acquisition technique in online applications is based on the placement of high-frequency current transformer (HFCT) sensors in the grounding cables of facilities, the test platform is mainly adapted to carry out measurements with this type of sensor. The designed and developed test platform was validated to assess its features and the degree of convergence with a real installation, showing the convenience of its use for the appropriate and standardized characterization of PD-measuring systems.

A Novel Time Alignment Technique for Online PD Location in Covered Conductors

Partial discharge diagnosis by simultaneous observation of discharge pulses and vibration signal

Detection of Inter-Turn Short Circuit Fault for Dual Three-Phase PMSM Based on Vector Space Decomposition Scheme

Discrimination of Three or More Partial Discharge Sources by Multi-Step Clustering of Cumulative Energy Features

Detection and Identification Technologies of Wide Band Partial Discharge

Advanced techniques for on-line PD measurements in high voltage systems

A novel calibration method for PD measurements in power cables and joints using capacitive couplers

Uneven Demagnetization Fault Diagnosis in Dual Three-Phase Permanent Magnet Machines Based on Electrical Signal Difference

Efficient and Low-Cost PD Monitoring and Locating System for MV Switchgears Using TEV Detectors

Partial Discharge Automatic Locating Algorithm for Cable under Oscillatory Wave Voltage Conditions Based on Traveling Wave Method

A Novel Oscillation Wave Test System for Partial Discharge Detection in XLPE Cable Lines

Application of HFCT and UHF Sensors in On-Line Partial Discharge Measurements for Insulation Diagnosis of High Voltage Equipment

Partial Discharge Detection Technology for Switchgear Based on Near-Field Detection

Novel Reference Method for the Characterization of PD Measuring Systems Using HFCT Sensors

Electromagnetic time reversal for online partial discharge location in power cables: Influence of interfering reflections from grid components

Application to Real Power Networks of a Method to Locate Partial Discharges Based on Electromagnetic Time Reversal

Scale Modular Test Platform for the Characterization of PD Measuring Systems Using HFCT Sensors

Design of Transmission Line and Electromagnetic Field Sensors for DC Partial Discharge Analysis

Modeling and experimental verification of on-line PD detection in MV covered-conductor overhead networks

A Pulse Interference Suppression Method Based on Double-Sensor Detection for PD Measurement in Frequency-Tuned Resonant Tests

Non-Contact Voltage Reconstruction Method Based on Dual-Pin Type Probes Structure and Measuring Point Optimization for AC Overhead Transmission Lines