Abstract:Due to the increase in voltage levels and line lengths of power cables, the commonly used alternating current resonance (ACR) voltage is challenging to meet the growth rate of the capacitance of ultrahigh-voltage cables for the on-site partial discharge (PD) tests. PD research on power–frequency-like voltages, such as damped alternating current (DAC) voltage, very low-frequency sine wave (VLF-Sine) voltage, and very low-frequency cosine rectangular wave (VLF-CR) voltage, has important engineering value for evaluating the cable insulation conditions. In this article, a PD test and measurement system of a 10-kV cross-linked polyethylene (XLPE) cable line with a 2 km length is established. Seven typical accessory defects are made artificially, including insulation hole, insulation screen tip, ring-cut tool mark, and stress cone installation dislocation defects at the terminals; and connector tip, conductive impurity, and stress cone installation dislocation defects at the joints. PD tests under four kinds of testing voltages of ACR, DAC, VLF-Sine, and VLF-CR are carried out to compare the PD inception voltages (PDIV), phase-resolved PD (PRPD) patterns, and PD location results of various defects. PD equivalence between power–frequency-like voltages and ACR is characterized by the PDIV equivalent coefficient ${K}_{\text {PDIV}}$ , PRPD pattern characteristic quantities, and discharge amplitudes. The results show that DAC and VLF-Sine have an outstanding ability to detect and characterize the severity of PD. DAC and VLF-CR have a good ability to recognize the type of PD. Also, DAC, VLF-Sine, and VLF-CR can accurately locate PD. This study provides an important reference for on-site cable defect diagnosis and PD assessment.

Sdmf Based Interference Rejection And Pd Interpretation For Simulated Defects In Hv Cable Diagnostics

Radio-frequency Detection of Partial Discharge in Power Cable Joints

Comparative Study on Partial Discharge Characteristics of Seven Accessory Defects under Four On-Site Testing Voltages of a 10-Kv Cable Line

A successful on-site PD testing experience of 11kV EPR cable insulation systems

A Thermal Excitation Based Partial Discharge Detection Method for Cable Accessory

A Partial Discharge Detection System for XLPE Cable Terminals and Acoustic Wave Sensing Characteristics Based on Fiber Optic Mach-Zehnder Interferometer

Voltage Equivalence of Partial Discharge Tests for XLPE Insulation Defects

A Distributed Pd Detection Method for High Voltage Cables Based on High Precision Clock Synchronization

Study of Partial Discharges Measurement Cycles Effect on Defect Recognition for Underground Cable Joints

Research on Partial Discharge Characteristics and Type Identification of Typical Insulation Defects of 10kv XLPE Cables

Partial Discharge Pattern Recognition of XLPE Cables at DC Voltage Based on the Compressed Sensing Theory

Partial Discharge Detection on 320 Kv VSC-HVDC XLPE Cable with Artificial Defects under DC Voltage

Transfer Functions for RF Partial Discharge Signals in Power Cable Joints

Cable Insulation Fault Identification Using Partial Discharge Patterns Analysis

Distributed Detection and Acoustic Emission Waveform Retrieval of Cable Joint Partial Discharge

Studies on electric field distribution and partial discharges of XLPE cable at DC voltage

Partial Discharge Characteristics and Mechanism of Medium Voltage Power Cable Defects under Different Voltage Stresses

Implementation of A Novel Double-Side Technique for Partial Discharge Detection and Location in Covered Conductor Overhead Distribution Networks

Review on Detection and Analysis of Partial Discharge along Power Cables

Defects Location of Multi-Impedance Mismatched of Power Cables Based on FDR Method with Dolph-Chebyshev Window

Partial discharge detection on power equipment using a magneto-resistive sensor