Abstract:Since most of the cable-driven parallel manipulators (CDPMs) are small in dimension or low in speed, the self-weight or inertia of the cable is neglected when dealing with the problems of kinematics, dynamics and workspace. The cable is treated as a massless straight line, and the inertia of the cable is not discussed. However, the camera robot is a large-span high-speed CDPM. Thus, the self-weight and inertia of the cable cannot be negligible. The curved cable due to the self-weight is modeled as a catenary to accurately account for its sagging effect. Moreover, the dynamic model of the camera robot is derived by decomposing the motion of the cable into an in-plane motion and an out-plane motion, based on which an iterative-based tension distribution algorithm and a workspace generation algorithm are presented. An optimization model is presented to simultaneously improve the workspace volume, anti-wind disturbance ability and impulse of tensions on the camera and pan–tilt device system (CPTDS) by selecting the proper optimal variables under the linear and nonlinear constraints. An improved genetic algorithm (GA) is proposed, and the simulation results demonstrate that the improved GA offers a stronger ability in global optimization compared to the standard genetic algorithm (SGA). The ideal-point method is employed to avoid the subjective influence of the designer when performing the multi-objective optimization, and a remarkable improvement of the performance is obtained through the optimization. Furthermore, the distribution characteristics of the optimization objects are studied, and some valuable conclusions are summarized, which will provide some valuable references in designing large-span high-speed CDPMs.

Stiffness-Oriented Cable Tension Distribution Algorithm For A 3-Dof Cable-Driven Variable-Stiffness Module

Cable Tension Analysis Oriented the Enhanced Stiffness of a 3-DOF Joint Module of a Modular Cable-Driven Human-Like Robotic Arm

Tension Optimization of a Cable-Driven Coupling Manipulator Based on Robot Dynamics with Cable Elasticity.

Stiffness Optimization of Cable-Driven Humanoid Manipulators

Design and Stiffness Analysis of a Novel 7-DOF Cable-Driven Manipulator

Kinematic analysis and design optimization of a cable-driven universal joint module

Tension Optimization of a Cable-Driven Robot by Screw Statics

A Novel Cable-Driven Joint Module for Space Manipulators: Design, Modeling, and Characterization

Research on Controllable Stiffness of Redundant Cable-Driven Parallel Robots

Stiffness Modeling and Dynamics Co-Modeling for Space Cable-Driven Linkage Continuous Manipulators

Analytic Center-Based Tension Distribution for Cable-Driven Platforms

Design and Analysis of 7-DOF Cable-Driven Manipulator

Configuration Synthesis for Fully Restrained 7-Cable-driven Manipulators

Variable Stiffness and Antagonist Actuation for Cable-Driven Manipulators Inspired by the Bird Neck

Design of a Variable Stiffness Quasi-Direct Drive Cable-Actuated Tensegrity Robot

Hybrid Tension-Position Control of Cable-Driven Serial Manipulator to Improve Accuracy and Avoid Cable Slack and Breakage

Development of a linear decoupling cable-driven manipulator with independent driving joints ,

Dynamic Modeling and Experimental Verification of a Cable-Driven Continuum Manipulator with Cable-Constrained Synchronous Rotating Mechanisms

Dynamic Modeling, Workspace Analysis and Multi-Objective Structural Optimization of the Large-Span High-Speed Cable-Driven Parallel Camera Robot

An Efficient Dynamic Modeling and Simulation Method of a Cable-Constrained Synchronous Rotating Mechanism for Continuum Space Manipulator

Design and validation of cable-driven hyper-redundant manipulator with a closed-loop puller-follower controller